INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
(a) Insert the 5 hooks, install 6 new bolts, 2 new clips with pins and 2 new spacers to install the curtain shield airbag assembly.
Text in Illustration
*1 |
Clip |
*2 |
Spacer |
*a |
Pin |
*b |
Hook |
Torque:
12.5 N·m {127 kgf·cm, 9 ft·lbf}
NOTICE:
Do not twist the curtain shield airbag assembly.
(b) Connect the connector NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness. |
|
(c) Push in the airbag connector lock to install the airbag connector.
2. INSTALL ROOF HEADLINING ASSEMBLY
Click here
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
4. INSPECT SRS WARNING LIGHT
Click here
Sliding Roof does not Move by Operating Sliding Roof Control Switch
DESCRIPTION
The sliding roof ECU (sliding roof drive gear sub-assembly) receives slide and
tilt signals when the sliding roof switch is operated and drives its built-in motor.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before ...
Engine Control System Malfunction (C1201)
DESCRIPTION
If a malfunction in the engine control system is detected, VSC and TRAC operations
are prohibited by the fail-safe function.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1201
Engine Control System ...
Acceleration Sensor Malfunction (C1420)
DESCRIPTION
Refer to DTCs C1419 and C1435 (See page ).
DTC Code
DTC Detection Condition
Trouble Area
C1420
After the difference between GL1 and GL2 becomes 0.6 G or more with the
vehicle stationary, the difference remains 0.4 G or m ...