INSTALLATION
PROCEDURE
1. INSTALL CLUTCH PEDAL NO.1 CUSHION
(a) Install the clutch pedal No. 1 cushion to the clutch pedal sub-assembly.
2. INSTALL CLUTCH PEDAL SHAFT COLLAR
(a) Apply MP grease to the clutch pedal shaft collar.
Text in Illustration
MP grease |
(b) Install the clutch pedal shaft collar to the clutch pedal sub-assembly.
3. INSTALL CLUTCH PEDAL BUSH
(a) Apply MP grease to 2 new bushes.
Text in Illustration
MP grease |
(b) Install the 2 bushes to the clutch pedal sub-assembly.
4. INSTALL CLUTCH PEDAL PAD
5. INSTALL CLUTCH PEDAL SPRING HOLDER
(a) Apply MP grease to the contact surface of the clutch pedal spring holder and clutch pedal support.
Text in Illustration
MP grease |
(b) Install the clutch pedal spring holder.
6. INSTALL CLUTCH PEDAL SUB-ASSEMBLY
(a) Install the clutch pedal sub-assembly to the clutch pedal support with the bolt and nut.
Torque:
34 N·m {350 kgf·cm, 25 ft·lbf}
HINT:
Install the bolt from the left side of the vehicle.
7. INSTALL TURN OVER SPRING SEAT COMPRESSION SPRING
(a) Apply MP grease to the contact surfaces of the clutch pedal sub-assembly and the compression spring.
Text in Illustration
MP grease |
(b) Install the compression spring to the clutch pedal sub-assembly and the clutch pedal spring holder.
8. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY
(See page )
Clearance Warning ECU Power Source Circuit
DESCRIPTION
This circuit provides power to operate the clearance warning ECU assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuse for circuits related to this system before performing the following
inspection procedure.
PROCEDURE
1.
CHECK HARNES ...
Initialization
INITIALIZATION
1. RESET MEMORY
NOTICE:
Perform Reset Memory (AT initialization) when replacing the automatic
transmission assembly, transmission valve body assembly or any of the shift
solenoid valves.
Reset Memory can be performed only with the Techstream.
HINT:
The E ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT COOLER (ROOM TEMPERATURE. SENSOR) THERMISTOR
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Text in Illustration
*a
Component without harness connected
(coo ...