INITIALIZATION
1. RESET MEMORY
NOTICE:
HINT:
The ECM memorizes the vehicle conditions when the ECT controls the automatic transmission assembly and transmission valve body assembly. Therefore, when the automatic transmission assembly, transmission valve body assembly or any of the shift solenoid valves has been replaced, it is necessary to reset the memory so that the ECM can memorize the new information.
The reset procedure is as follows.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Transmission / Utility / Reset Memory.
NOTICE:
After performing Reset Memory, be sure to perform the Road Test (See page ) described earlier.
HINT:
The ECM learns through the Road Test.
Diagnosis System
DIAGNOSIS SYSTEM
1. DIAGNOSIS
(a) If the skid control ECU (master cylinder solenoid) detects a malfunction,
the ABS and/or BRAKE warning lights and the slip indicator lights come on in accordance
with the trouble area to warn the driver.
HINT:
The DTCs are simultaneously stored in th ...
Luggage compartment features
Behind the rear seat (Double
Cab models only)
1.Cargo net hooks (vehicles with sub woofer)
2.Grocery bag hooks
3.Flashlight holder
4.Storage boxes
Deck
1. Auxiliary boxes
2. Tie-down cleats
3. Deck hooks
Auxiliary boxes
Left side
1. Turn the knob counterclockwise.
2. Open the ...
Multi-terrain Select Indicator Light does not Come ON
DESCRIPTION
When the transfer gear position is L4, the multi-terrain select indicator light
illuminates and control begins.
Under any of the following conditions, the multi-terrain select system does not
begin control and the multi-terrain select indicator light does not illuminate.
Th ...