Toyota Tacoma (2015-2018) Service Manual: Clutch Pedal Switch
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK CLUTCH START SYSTEM
(a) Check that the engine does not start when the clutch pedal is released.
(b) Check that the engine starts when the clutch pedal is fully depressed.
If necessary, replace the clutch start switch assembly.
Inspection
INSPECTION
PROCEDURE
1. INSPECT CLUTCH START SWITCH ASSEMBLY
(a) Measure the resistance between the terminals when the switch is ON and OFF.
|
Switch Position |
Specified Condition |
|---|---|
|
ON (pushed) |
Below 1 Ω |
|
OFF (free) |
10 kΩ or higher |
Removal
REMOVAL
PROCEDURE
1. REMOVE CLUTCH START SWITCH ASSEMBLY
(a) Disconnect the clutch start switch assembly connector.
(b) Remove the nut and clutch start switch assembly from the clutch pedal support.
Installation
INSTALLATION
PROCEDURE
1. INSTALL CLUTCH START SWITCH ASSEMBLY
(a) Install the clutch start switch assembly with the nut.
Torque:
16 N·m {160 kgf·cm, 12 ft·lbf}
(b) Connect the clutch start switch assembly connector.
2. INSPECT CLUTCH START SWITCH ASSEMBLY
.gif)
Installation
INSTALLATION
PROCEDURE
1. INSTALL CLUTCH PEDAL NO.1 CUSHION
(a) Install the clutch pedal No. 1 cushion to the clutch pedal sub-assembly.
2. INSTALL CLUTCH PEDAL SHAFT COLLAR
(a) Apply MP grease t ...
Clutch Release Cylinder(for R156f)
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. DRAIN CLUTCH FLUID
2. REMOVE FRONT PROPELLER SHAFT ASSEMBLY
(See page )
3. DISCONNECT CLUTCH RELEASE CYLINDER TO FLEXIBL ...
Other materials:
Sound Quality is Bad Only when CD is Played (Volume is Too Low)
PROCEDURE
1.
REPLACE CD AND RECHECK
(a) Replace the CD with a known good one and recheck.
(1) Check if the same malfunction occurs again.
OK:
Malfunction disappears.
OK
END
NG
REPLACE NAVIGATION RECEIVER ASSEMBLY ...
If you have a flat tire
Remove the flat tire and replace it with the spare provided.
■ Before jacking up the vehicle
● Stop the vehicle on a hard, flat surface.
● Set the parking brake.
● Shift the shift lever to P (automatic transmission) or R (manual transmission).
● Stop the engine.
& ...
Engine Switch Illumination Circuit
DESCRIPTION
The illuminated entry system controls the engine switch illumination.
WIRING DIAGRAM
PROCEDURE
1.
READ VALUE USING TECHSTREAM (POWER/ENGINE SW LIGHT)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch to ON.
(c) Turn the Techstream ...
