INSPECTION
PROCEDURE
1. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY
(a) Using a dial indicator, measure the inside diameter of the front oil pump body sub-assembly bushing. Maximum inside diameter: 38.138 mm (1.50 in.) If the inside diameter is more than the maximum inside diameter, replace the front oil pump body sub-assembly. |
|
2. INSPECT STATOR SHAFT ASSEMBLY
(a) Using a dial indicator, measure the inside diameter of the stator shaft assembly bushing. Maximum inside diameter: 22.227 mm (0.875 in.) If the inside diameter is more than the maximum inside diameter, replace the stator shaft assembly. |
|
3. INSPECT CLEARANCE OF OIL PUMP ASSEMBLY
(a) Push the front oil pump driven gear to one side of the front oil pump body sub-assembly. |
|
(b) Using a feeler gauge, measure the clearance.
Standard body clearance:
0.10 to 0.17 mm (0.00394 to 0.00669 in.)
If the body clearance is more than the standard clearance, check the front oil pump drive gear, front oil pump driven gear and front oil pump body sub-assembly.
(c) Using a feeler gauge, measure the clearance between the front oil pump driven gear teeth and the front oil pump drive gear teeth. Standard tip clearance: 0.07 to 0.15 mm (0.00276 to 0.00590 in.) If the tip clearance is more than the standard clearance, check the front oil pump drive gear, front oil pump driven gear and front oil pump body sub-assembly. |
|
(d) Using a steel straightedge and a feeler gauge, measure the side clearance of both gears. Standard side clearance: 0.03 to 0.05 mm (0.00118 to 0.00196 in.) If the side clearance is more than the standard thickness, check the front oil pump drive gear, front oil pump driven gear and front oil pump body sub-assembly. |
|
4. INSPECT OIL PUMP DRIVE GEAR ROTATION
(a) Install the oil pump assembly to the torque converter assembly.
(b) Check that the front oil pump drive gear rotates smoothly. |
|
(c) Remove the oil pump assembly from the torque converter assembly.
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
*A
w/ Seat Heater System
-
-
*1
FRONT SEAT CUSHION HEATER ASSEMBLY
*2
FRONT SEATBACK HEATER ASSEMBLY
...
Front Radar Sensor Incorrect Axial Gap (C1A11)
DESCRIPTION
When the vehicle is determined to be driving in a straight line or on a gradual
curve based on signals from the yaw rate sensor, etc., the millimeter wave radar
sensor assembly performs self diagnosis to check if the sensor beam axis has deviated.
If the millimeter wave radar sens ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
If the millimeter wave radar sensor assembly has been struck or dropped, replace
the millimeter wave radar sensor assembly with a new one.
PROCEDURE
1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
(a) for Type A:
(1) Engage the 2 gu ...