DESCRIPTION
This is output when the ECM detects malfunctions in the internal circuit.
DTC Code |
DTC Detection Condition |
Trouble Area |
MIL |
Note |
---|---|---|---|---|
P057504 |
|
ECM |
Does not come on |
SAE: P0575 |
P057549 |
PROCEDURE
1. |
CHECK FOR DTC |
(a) Clear the DTCs (See page ).
(b) Perform the following to make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the malfunction cannot be detected.
(1) Drive the vehicle at a speed for which cruise control operation is possible.
(2) Turn the cruise control system on using the cruise control main switch (ON/OFF).
(3) Push the cruise control main switch to -SET to begin control of vehicle speed using the cruise control system.
(c) Check the DTCs (See page ).
OK:
DTC P057504 and P057549 are not output.
OK |
USE SIMULATION METHOD TO CHECK |
NG |
REPLACE ECM |
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Manual Transmission System
DTC Code
Detection Item
MIL
Memory
See page
P03352A
Crankshaft Position Sensor "A" Signal Stuck in Range
Does not come on
DTC ...
Invalid Data Received from Deceleration Sensor (C1442,C1443)
DESCRIPTION
The airbag sensor assembly has a built-in yaw rate and acceleration sensor.
The skid control ECU (brake actuator assembly) receives signals from the yaw
rate and acceleration sensor (airbag sensor assembly) via the CAN communication
system.
DTC No.
Detection ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the engine immobiliser system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
2.
...