Toyota Tacoma (2015-2018) Service Manual: Lost Communication with Vehicle Dynamics Control Module Missing Message (U012287)
DESCRIPTION
The ECM receives signals from the skid control ECU (brake actuator assembly) via CAN communication.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
MIL |
Note |
|---|---|---|---|---|
|
U012287 |
While cruise control main switch ON, communication stop between skid control ECU (brake actuator assembly) continues for 2.6 seconds or more |
|
Does not come on |
SAE: U0122 |
CAUTION / NOTICE / HINT
HINT:
Refer to troubleshooting in CAN Communication System (See page
.gif)
).
PROCEDURE
|
1. |
CHECK FOR DTC |
(a) Clear the DTCs (See page ).
(b) Perform the following to make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the malfunction cannot be detected.
(1) Drive the vehicle at a speed for which cruise control operation is possible.
(2) Turn the cruise control system on using the cruise control main switch (ON/OFF).
(3) Push the cruise control main switch to -SET to begin control of vehicle speed using the cruise control system.
(c) Check the DTCs (See page ).
OK:
DTC U012287 is not output
| OK | .gif) |
USE SIMULATION METHOD TO CHECK |
| NG | |
GO TO CAN COMMUNICATION SYSTEM |
Cruise Control System Internal Failure (P057504,P057549)
DESCRIPTION
This is output when the ECM detects malfunctions in the internal circuit.
DTC Code
DTC Detection Condition
Trouble Area
MIL
Note
...
Vehicle Control History
VEHICLE CONTROL HISTORY
VEHICLE CONTROL HISTORY
(a) A part of the control history can be confirmed using the vehicle control
history.
Click here ...
Other materials:
While Alarm is Armed, Engine Hood is opened but Alarm does not Sound
DESCRIPTION
A situation in which the alarm is armed but does not sound when the hood is opened
can be caused when the main body ECU (multiplex network body ECU) cannot detect
whether the hood courtesy switch is open or closed.
If the alarm does not sound, there may be a malfunction in the hood ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL FLYWHEEL HOUSING SIDE COVER
(a) Install the flywheel housing side cover to the cylinder block sub-assembly.
2. INSTALL STARTER ASSEMBLY
(a) Install the starter assembly with the 2 bolts.
Torque:
37 N·m {377 kgf·cm, 27 ft·lbf}
(b) Connect the engine wire ...
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very useful because intermittent conditions or signals ...
