DESCRIPTION
DTC No. |
DTC Detection Condition |
Trouble Area |
MIL |
Note |
---|---|---|---|---|
P057113 |
|
|
Does not come on |
SAE: P0571 |
CAUTION / NOTICE / HINT
NOTICE:
First check the CAN communication systems by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed to troubleshooting (See page ).
PROCEDURE
1. |
CHECK FOR DTC (VEHICLE STABILITY CONTROL SYSTEM) |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch on.
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
(e) Check for DTCs (See page ).
OK:
Vehicle stability control system DTCs are not output.
Result
Result |
Proceed to |
---|---|
OK |
A |
NG (for Hydraulic Brake Booster) |
B |
NG (for Vacuum Brake Booster) |
C |
B |
GO TO VEHICLE STABILITY CONTROL SYSTEM |
C |
GO TO VEHICLE STABILITY CONTROL SYSTEM |
|
2. |
CHECK FOR DTC (CRUISE CONTROL SYSTEM) |
(a) Clear the DTCs (See page ).
(b) Perform the following to make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the malfunction cannot be detected.
(1) Drive the vehicle at a speed for which cruise control operation is possible.
(2) Turn the cruise control system on using the cruise control main switch (ON/OFF).
(3) Push the cruise control main switch to -SET to begin control of vehicle speed using the cruise control system.
(c) Check the DTCs (See page ).
OK:
DTC P057113 is not output
OK |
USE SIMULATION METHOD TO CHECK |
NG |
REPLACE ECM |
Inspection
INSPECTION
PROCEDURE
1. INSPECT RADIATOR CORE SUB-ASSEMBLY
Check the core plate for damage.
Text in Illustration
*1
Core Plate
*2
Radiator Core
If the sides of the core plate groove are deformed, it is impossible
to reassem ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY
HINT:
Use the same procedure for the side.
(a) Install the child restraint seat anchor bracket sub-assembly with the 2 bolts.
Torque:
30 N·m {306 kgf·cm, 22 ft·lbf}
(b) Reinstall the floor carpet.
2. INST ...
Rear Cross Traffic Alert Buzzer
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR CROSS TRAFFIC ALERT BUZZER
(a) Engage the clamp to install the rear cross traffic alert buzzer.
(b) Connect the connector.
2. INSTALL QUARTER INSIDE TRIM BOARD LH (for Double Cab)
(See page )
3. ...