Toyota Tacoma (2015-2018) Service Manual: Vehicle Control History

Fail-safe Chart

FAIL-SAFE CHART HINT: If any of the following auto cancel conditions are detected while the dynamic radar cruise control system is controlling vehicle speed, the system clears the stored vehicle ...

Communication Error from ECM to VSC Invalid Serial Data Received (P163181)

DESCRIPTION The ECM sends signals such as dynamic radar cruise control operation signals, brake operation demand signals and buzzer operation demand signals to the skid control ECU (master cylind ...

Other materials:

Check Bus 3 Line for Short to GND
DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 6 (CA3H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 21 (CA3L) of the central gateway ECU (network gateway ECU) and ...

Rear Axle Hub Bolt
Installation INSTALLATION PROCEDURE 1. INSTALL REAR AXLE HUB BOLT (a) Install a new hub bolt through the axle hub. (b) Install the washer plate, as shown in the illustration, through the hub bolt, and install the hub bolt by tightening the hub nut. 2. APPLY HIGH TEMPERATURE GREASE 3. ...

Acceleration Sensor Power Supply Voltage Malfunction (C1381)
DESCRIPTION The skid control ECU (master cylinder solenoid) receives signals from the yaw rate and acceleration (airbag sensor assembly) via the CAN communication system. The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle's condition using 2 ...