TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Lighting / Stop Light Switch

Toyota Tacoma (2015-2018) Service Manual: Stop Light Switch

Components

COMPONENTS

ILLUSTRATION

Inspection

Inspection

INSPECTION

PROCEDURE

1. INSPECT STOP LIGHT SWITCH

(a) Check the resistance.

(a) Check the resistance.

(1) Measure the resistance using an ohmmeter, and check the results in accordance with the value(s) in the table below.

Standard:

Tester Connection

Condition

Specified Condition

1-2

Switch pin free

Below 1 Ω

3-4

Switch pin free

10 kΩ or higher

1-2

Switch pin pushed in

10 kΩ or higher

3-4

Switch pin pushed in

Below 1 Ω

If the result is not as specified, replace the stop light switch assembly.

Installation

INSTALLATION

PROCEDURE

1. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

(a) Engage the 2 claws to install a new stop light switch mounting adjuster.

2. INSTALL STOP LIGHT SWITCH ASSEMBLY

(a) Insert the stop light switch assembly to the stop light switch mounting adjuster until the switch body slightly touches the brake pedal.

NOTICE:

Do not depress the brake pedal.

(b) Rotate the stop light switch assembly clockwise by approximately one fourth of a rotation.

Text in Illustration

*a

Protrusion Amount Measurement Area

(c) Check the protrusion amount of the shaft.

Standard:

1.5 to 2.6 mm (0.0591 to 0.1024 in.)

(d) Connect the connector.

3. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

(See page ) ) )

Removal

REMOVAL

PROCEDURE

1. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

(See page ) ) )

2. REMOVE STOP LIGHT SWITCH ASSEMBLY

(a) Disconnect the connector.

(b) Turn the stop light switch assembly counterclockwise to remove it.

3. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

(a) Using a screwdriver, disengage 2 claws to remove the stop light switch mounting adjuster.

NOTICE:

The stop light switch mounting adjuster must not be reused.
    Related Tacoma materials

    Brake Control Signal Mismatch (C1A69)
    DESCRIPTION The skid control ECU (master cylinder solenoid)*1 or skid control ECU (brake actuator assembly)*2 sends signals to the millimeter wave radar sensor assembly according to the brake control status. If the millimeter wave radar sensor assembly receives a vehicle stability control sys ...

    Dtc Check / Clear
    DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the back sonar or clearance sonar switch assembly on. (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / Intuitive P/A / Trouble Codes. (f) Check for D ...

    Removal
    REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab) 2. REMOVE FRONT DOOR SCUFF PLATE LH (for Access Cab) 3. REMOVE COWL SIDE TRIM BOARD LH 4. REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY 5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY 6. ...