TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / 2gr-fks Engine Mechanical / Front Crankshaft Oil Seal

Toyota Tacoma (2015-2018) Service Manual: Front Crankshaft Oil Seal

Components

COMPONENTS

ILLUSTRATION

Installation

Installation

INSTALLATION

PROCEDURE

1. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL

(a) Apply MP grease to the lip of a new timing gear case or timing chain case oil seal.

(b) Using SST and a hammer, tap in the timing gear case or timing chain case oil seal until its surface is flush with the timing chain cover edge.

SST: 09226-10010

NOTICE:

  • Keep the lip free from foreign matter.
  • Do not tap the oil seal at an angle.

2. INSTALL CRANKSHAFT PULLEY

3. INSTALL OIL FILTER BRACKET SUB-ASSEMBLY (w/ Oil Cooler)

3. INSTALL OIL FILTER BRACKET SUB-ASSEMBLY (w/ Oil Cooler)

4. INSTALL OIL FILTER BRACKET SUB-ASSEMBLY (w/o Oil Cooler)

4. INSTALL OIL FILTER BRACKET SUB-ASSEMBLY (w/o Oil Cooler)

5. CONNECT NO. 1 WATER BY-PASS PIPE (w/ Oil Cooler)

5. CONNECT NO. 1 WATER BY-PASS PIPE (w/ Oil Cooler)

6. INSTALL RADIATOR ASSEMBLY

6. INSTALL RADIATOR ASSEMBLY

(See page Removal )

Removal

REMOVAL

PROCEDURE

1. REMOVE RADIATOR ASSEMBLY

(See page 2. DISCONNECT NO. 1 WATER BY-PASS PIPE (w/ Oil Cooler) )

2. DISCONNECT NO. 1 WATER BY-PASS PIPE (w/ Oil Cooler)

3. REMOVE OIL FILTER BRACKET SUB-ASSEMBLY (w/ Oil Cooler)

3. REMOVE OIL FILTER BRACKET SUB-ASSEMBLY (w/ Oil Cooler)

4. REMOVE OIL FILTER BRACKET SUB-ASSEMBLY (w/o Oil Cooler)

4. REMOVE OIL FILTER BRACKET SUB-ASSEMBLY (w/o Oil Cooler)

5. REMOVE CRANKSHAFT PULLEY

5. REMOVE CRANKSHAFT PULLEY

6. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL

6. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL

(a) Using a screwdriver, pry out the timing gear case or timing chain case oil seal.

NOTICE:

Do not damage the surface of the oil seal press fit hole or crankshaft.

HINT:

Tape the screwdriver tip before use.
    Related Tacoma materials

    Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY (a) Put matchmarks on the steering intermediate shaft assembly and steering main shaft assembly. (b) Remove the bolt and steering intermediate shaft assembly. 2. REMOVE UPPER STEERING COLUMN BRACKET WITH SWITCH ASSEMBLY (w ...

    Tire Pressure Monitoring System (TPMS)
    The Toyota Tacoma is equipped with a tire pressure warning system that monitors tire inflation pressure through dedicated tire pressure warning valves and transmitters. By detecting an underinflated tire before the condition becomes more serious, the system provides the driver with an early indicati ...

    Parking brake
    Lever type ● Sets the parking brake Fully set the parking brake while depressing the brake pedal. At this time, the indicator will come on. ● Release the parking brake Press the button Turn the lever clockwise Press it in completely Pedal type Sets the parking brake*. ...