Toyota Tacoma (2015-2018) Service Manual: Radio Antenna Cord

Toyota Tacoma (2015-2018) Service Manual / Audio / Video / Radio Antenna Cord

Components

COMPONENTS

ILLUSTRATION

Removal

REMOVAL

PROCEDURE

1. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY

(See page 2. REMOVE ANTENNA CORD SUB-ASSEMBLY )

2. REMOVE ANTENNA CORD SUB-ASSEMBLY

(a) Disengage the 4 clamps to remove the antenna cord sub-assembly.

Installation

INSTALLATION

PROCEDURE

1. INSTALL ANTENNA CORD SUB-ASSEMBLY

(a) Engage the 4 clamps to install the antenna cord sub-assembly.

2. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY

(See page Radio Receiver )

Radio Antenna

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE ROOF HEADLINING ASSEMBLY (for Double Cab) (See page ) 2. REMOVE ROOF HEADLINING ASSEMBLY (for Access Cab) (See p ...

Radio Receiver

Components COMPONENTS ILLUSTRATION ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY (See page ) 2. REMOVE RADIO AND DISPLAY RECEI ...

Other materials:

Inspection
INSPECTION PROCEDURE 1. INSPECT TRANSMISSION FLOOR SHIFT ASSEMBLY (w/o Smart Key System) HINT: If the results of the following inspections are as specified but a malfunction has occurred, replace the transmission floor shift assembly. (a) Inspect the wire harness. (1) Disconnect the shift lo ...

Initialization not Completed (C2177/77)
DESCRIPTION Initialization is necessary if one of the following occurs: The tire pressure warning ECU and receiver is replaced. A tire pressure warning valve and transmitter is replaced. Tires with different standard tire pressures are installed. The tires are rotated. A new ...

Stop Light Switch
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT STOP LIGHT SWITCH (a) Check the resistance. (1) Measure the resistance using an ohmmeter, and check the results in accordance with the value(s) in the table below. Standard: Tester Connectio ...