Toyota Tacoma (2015-2018) Service Manual: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- When an open circuit indication is displayed by the self-check function, check for DTCs and troubleshoot according to each inspection procedure.
|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
System does not operate at all |
Proceed to "Clearance Warning ECU Power Source Circuit" |
|
|
Proceed to "Clearance Sonar Main Switch Circuit" |
|
|
|
System cannot be turned off |
Proceed to "Clearance Sonar Main Switch Circuit" |
|
.gif)
|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
Combination meter assembly (shift position indicator) operates normally, but detection operates when shift lever is in any position other than R, or does not operate with shift lever in R (rear sonar) |
CAN communication system |
|
|
Clearance warning ECU assembly |
|
|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
Sonar detection operation is normal but buzzer operation is intermittent |
Proceed to "Clearance Warning Buzzer Circuit" |
|
|
Clearance warning ECU assembly |
|
|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
Detection operation is normal but all sonar displays do not appear on multi-information display and multi-display |
CAN communication system |
|
|
Clearance warning ECU assembly |
|
|
|
Detection operation is normal but sonar displays do not appear on multi-information display |
CAN communication system |
|
|
Combination meter assembly |
|
|
|
Clearance warning ECU assembly |
|
Customize Parameters
CUSTOMIZE PARAMETERS
PROCEDURE
1. CUSTOMIZE INTUITIVE PARKING ASSIST SYSTEM
(a) Customizing with the Techstream
NOTICE:
When the customer requests a change in a function, first make sure ...
Terminals Of Ecu
TERMINALS OF ECU
1. CLEARANCE WARNING ECU ASSEMBLY
(a) Disconnect the C30 connector from the clearance warning ECU assembly.
(b) Measure the voltage and resistance according to the value(s) in th ...
Other materials:
ECM Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
ECM Communication Stop Mode
Either condition is met:
Communication stop for "ECM (Engine)" is indicated on the "Communication
Bus Check" screen of the ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE REAR AXLE SHAFT SNAP RING
(a) Using a snap ring expander, remove the snap ring.
2. REMOVE REAR AXLE SHAFT
(a) Using SST and press, remove the rear axle shaft.
SST: 09521-25011
SST: 09521-25021
3. REMOVE REAR AXLE BEARING RETAINER INNER
(a) Remove the rear ...
System Description
SYSTEM DESCRIPTION
1. WIRELESS CHARGER FUNCTION OUTLINE
(a) The wireless charging system enables Qi-compliant* rechargeable devices,
such as a cellular phone, to be recharged by merely placing it on the charging area
of the mobile wireless charger cradle assembly on the console panel.
HINT:
...
