Toyota Tacoma (2015-2018) Service Manual: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
When ignition switch in ON position, SRS warning light occasionally comes on approximately 6 seconds after engine start. |
SRS warning light circuit malfunction (SRS Warning Light Remains ON). |
|
|
SRS warning light always comes on even when DTC not set. |
SRS warning light circuit malfunction (SRS Warning Light Remains ON). |
|
|
With ignition switch in ON position, SRS warning light does not come on. |
SRS warning light circuit malfunction (SRS Warning Light does not Come On). |
|
|
Although SRS warning light operates normally, neither DTCs normal system indication displayed. |
TC and CG Terminal Circuit |
|
|
Although terminals TC and CG not connected, DTC or normal system indication displayed. |
TC and CG Terminal Circuit |
|
.gif)
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...
System Description
SYSTEM DESCRIPTION
1. SRS (SUPPLEMENTAL RESTRAINT SYSTEM) AIRBAG SYSTEM
(a) General Description
(1) The SRS airbag system consists of the following airbag and main components:
Airbag
...
Other materials:
Deck Light Relay
Inspection
INSPECTION
PROCEDURE
1. REMOVE DECK LIGHT RELAY
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard:
Tester Connection
Condition
Specified Condition
...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE BRAKE ACTUATOR BRACKET NO. 1
(a) Using a hexagon wrench (5 mm), remove the screw and brake actuator bracket
No. 1.
(b) Using a screwdriver, remove the fluid level warning switch connector.
2. REMOVE BRAKE M ...
Communication Error from ECM to VSC (P1631)
DESCRIPTION
The ECM sends signals such as A/T information signals, dynamic radar cruise control
operation signals, brake operation demand signals, and buzzer operation demand signals
to the skid control ECU (brake actuator assembly) when the dynamic radar cruise
control is operating. Therefor ...
