PROBLEM SYMPTOMS TABLE
HINT:
|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
Wireless control function and entry function do not operate |
Proceed to "All Door Entry Lock / Unlock Functions and Wireless Functions do not Operate" |
|
|
Wireless control function does not operate but entry function operates |
Electrical key transmitter sub-assembly |
- |
|
Only answer-back function does not operate normally |
Proceed to "No answer-back" |
|
|
Only automatic lock function does not operate normally |
Perform operation check |
|
|
Lighting system (front door courtesy light switch circuit) |
|
|
|
Lighting system (rear door courtesy light switch circuit) |
|
|
|
Main body ECU (multiplex network body ECU) |
- |
|
|
Only illuminated entry function does not operate |
Perform operation check |
|
|
Lighting system |
|
|
|
Main body ECU (multiplex network body ECU) |
- |
|
|
Only door ajar warning function does not operate |
Perform operation check |
|
|
Lighting system (front door courtesy light switch circuit) |
|
|
|
Lighting system (rear door courtesy light switch circuit) |
|
|
|
Main body ECU (multiplex network body ECU) |
- |
|
|
Only panic alarm function does not operate |
Perform operation check |
|
|
Lighting system (interior lights) |
|
|
|
Lighting system (hazard warning lights) |
|
|
|
Horn system |
|
|
|
Main body ECU (multiplex network body ECU) |
- |
Operation Check
Diagnosis SystemSD Card Communication Malfunction (B158C)
DESCRIPTION
The navigation receiver assembly stores this DTC when the SD card cannot be mounted
when inserted into the SD card slot.
DTC Code
DTC Detection Condition
Trouble Area
B158C
The SD card cannot be mounted when inserted into t ...
Ptc Heater Assembly
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
(See page )
2. REMOVE INSTRUMENT LOWER PANEL ASSEMBLY
3. REMOVE AIR DUCT ASSEMBLY
4. REMOVE QUICK HEATER ASSEMBLY
(a) Disconnect the connector.
...
Short in Driver Side Squib 2nd Step Circuit (B1810/53-B1813/53)
DESCRIPTION
The driver side squib 2nd step circuit consists of the airbag sensor assembly,
the spiral cable with sensor sub-assembly and the horn button assembly.
The circuit signals the SRS to deploy when airbag deployment conditions are met.
These DTCs are set when a malfunction is detected i ...