Toyota Tacoma (2015-2018) Service Manual: Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
|
Expression |
Ignition Switch (Position) |
Engine Switch (Condition) |
|---|---|---|
|
Ignition switch off |
LOCK |
Off |
|
Ignition switch ACC |
ACC |
On (ACC) |
|
Ignition switch ON |
ON |
On (IG) |
|
Engine start |
START |
Start |
2. PRECAUTION FOR WHEN USING WIRELESS CHARGER
(a) If the mobile wireless charger cradle assembly surface becomes too hot during charging operation, the indicator lights (green and amber) on the mobile wireless charger cradle assembly will blink and charging will be canceled. If the surface cools down, the indicator light (amber) will be illuminated and charging will be resumed.
(b) A rechargeable device may not be recharged depending on the shape, material or thickness of accessories applied to it, such as a cellular phone cover.
(c) Do not put foreign matter or metal objects, such as a paper clip, between the charging area and the rechargeable device. Doing so may result in a charging failure, or burns or a fire due to overheating of the metal object.
(d) Do not apply a metallic object, such as an aluminum sticker, to the mobile wireless charger cradle assembly. Doing so may result in burns or a fire due to overheating of the metal object.
Parts Location
PARTS LOCATION
ILLUSTRATION
...
Other materials:
Initialization
INITIALIZATION
1. ZERO POINT CALIBRATION
NOTICE:
Make sure that the front passenger seat is not occupied before performing the
operation.
HINT:
Perform the zero point calibration and sensitivity check if any of the following
conditions apply.
The occupant detection ECU is replaced. ...
Oil Pressure Switch
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
(a) Disengage the clamp and disconnect the engine oil pressure switch
connector.
(b) Using a 24 mm deep socket ...
Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
NOTICE:
Do not try to remove the black nylon tube as it is welded to the fuel suction
tube assembly (See page
).
PROCEDURE
1. REMOVE FUEL SENDER GAUGE ASSEMBLY
2. REMOVE NO. 1 FUEL SUB-TANK
(a) Disconnect the 2 fuel pump connectors.
...
