Toyota Tacoma (2015-2018) Service Manual: Power Steering System

Installation

INSTALLATION PROCEDURE 1. INSTALL POWER STEERING LINK (a) Insert the power steering link into the vehicle in the order shown in the illustration. Install in this Direction ...

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT DRIVE BELT (a) Visually check the belt for defects, such as excessive wear and frayed cords. If any defects are found, replace the drive belt. HINT: ...

Other materials:

Rear seats (Access Cab and Double Cab models)
Access Cab models The bottom cushion of the rear seats can be raised and lowered. ■ Before raising the bottom cushion Stow the seat belt buckles. This prevents the seat belt buckles from falling out when you fold the seatback. ■ Raising the bottom cushion Raise the bottom cushi ...

Fuel Receiver Gauge Malfunction
DESCRIPTION The meter CPU uses the fuel sender gauge assembly to determine the level of the fuel in the fuel tank. The resistance of the fuel sender gauge will vary between approximately 13.5 Ω with the float at the full position, and 414.5 Ω with the float at the empty position. The meter ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE If a normal code is displayed during the DTC check but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page. NOTICE: When replacing the skid control ECU (master cylin ...