Toyota Tacoma (2015-2018) Service Manual: Operation Check
OPERATION CHECK
1. CHECK REMOTE CONTROL MIRROR FUNCTION
(a) Turn the ignition switch to ON.
(b) With L on the mirror select switch selected, check that the outer rear view mirror assembly LH surface moves up, down, left and right normally.
(c) With R on the mirror select switch selected, check that the outer rear view mirror assembly RH surface moves up, down, left and right normally.
2. CHECK MIRROR HEATER FUNCTION
(a) Turn the ignition switch to ON.
(b) Check that pressing the mirror heater switch illuminates the indicator and warms the mirror surfaces.
(c) Check that after approximately 15 minutes, the indicator light turns off and the mirror heater deactivates.
HINT:
There is a timer extension function which can operate the mirror heater system for up to an additional 45 minutes.
System Diagram
SYSTEM DIAGRAM
...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are lis ...
Other materials:
Customize Parameters
CUSTOMIZE PARAMETERS
PROCEDURE
1. CUSTOMIZE WIRELESS DOOR LOCK CONTROL SYSTEM
HINT:
The following items can be customized.
NOTICE:
When the customer requests a change in a function, first make sure that
the function can be customized.
Be sure to make a note of the current setti ...
Driver Side Seat Belt Warning Light does not Operate
DESCRIPTION
When the ignition switch is ON, the airbag sensor assembly transmits front seat
inner belt status signals to the combination meter assembly through CAN. If the
driver seat belt is not fastened, the combination meter assembly blinks the driver
side seat belt warning light. If the s ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
(a) Remove SST from the extension housing.
(b) Install the propeller shaft to the extension housing.
(c) Completely remove any oil or the like and clean the contact surfaces of the
propeller shaft flange and diff ...
