Toyota Tacoma (2015-2018) Service Manual: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT SHIFT LEVER POSITION
(a) When moving the shift lever from P to each position with the ignition switch ON and the brake pedal depressed, check that the shift lever moves smoothly and correctly into position.
(b) Start the engine and check that the vehicle moves forward when the shift lever is moved from N to D and moves rearward when the shift lever is moved to R.
If the operation is not as specified, inspect the park/neutral position switch and transmission floor shift assembly.
2. INSPECT SHIFT LOCK OPERATION
(a) Move the shift lever to P.
(b) Turn the ignition switch off.
(c) Check that the shift lever cannot be moved from P to any other position.
(d) Turn the ignition switch to ON, depress the brake pedal, and check that the shift lever can be moved to other position.
If the operation is not as specified, inspect the transmission floor shift assembly.
3. INSPECT SHIFT LOCK RELEASE BUTTON OPERATION
(a) Move the shift lever to P.
(b) Turn the ignition switch off.
(c) Remove the shift lock release button cover.
(d) When moving the shift lever with the shift lock release button pressed, check that the shift lever can be moved from P to any other position.
If the operation is not as specified, inspect the transmission floor shift assembly.
(e) Install the shift lock release button cover.
4. INSPECT KEY INTERLOCK OPERATION (w/o Smart Key System)
(a) Turn the ignition switch to ON.
(b) Depress the brake pedal and move the shift lever to any position other than P.
(c) Check that the ignition key cannot be turned to LOCK.
(d) Move the shift lever to P, turn the ignition key to LOCK and check that the ignition key can be removed.
If the operation is not as specified, inspect the transmission floor shift assembly.
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE SHIFT LOCK RELEASE BUTTON COVER
(a) Using a screwdriver with its tip wrapped in protective tape, detach the 2
claws to remove the shift lock release button cover f ...
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT CONSOLE BOX
(See page )
2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Move the shift lever to N.
(b) Disconnect the end of the transmission control ca ...
Other materials:
USB port/AUX port
Connect an iPod, USB memory device or portable audio player to the USB port/AUX
port as indicated below. Select “iPod”, “USB” or “AUX” on the “Select Audio Source”
screen and the device can be operated via multimedia system.
Connecting using the USB port/AUX port
■ iPod
...
Transfer L4 Position Switch Circuit (C1268)
DESCRIPTION
A-TRAC is activated if wheel skid is detected while the transfer is in the L4
position.
DTC Code
DTC Detecting Condition
Trouble Areas
C1268
L4 detection switch signal input to skid control ECU (master cylinder
solenoid ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE
1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY
(a) Check that the ignition switch is OFF.
(b) Check that the cable is disconnec ...
