Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Lost Communication with ECM (U0100,U0142,U0155)

DESCRIPTION

DTC No.

DTC Detecting Condition

Trouble Area

U0100

No communication with ECM

  • CAN communication system
  • ECM

U0142

No communication with main body ECU

  • CAN communication system
  • Main body ECU (multiplex network body ECU)

U0155

No communication with combination meter

  • CAN communication system
  • Combination meter assembly

PROCEDURE

1.

GO TO CAN COMMUNICATION SYSTEM

HINT:

Refer to CAN Communication System (See page ). ).

NEXT

END

Air Inlet Damper Position Sensor Circuit (B1432/32)
DESCRIPTION This sensor detects the position of the air inlet damper and sends the appropriate signals to the air conditioning amplifier assembly. The position sensor is built into the No. 1 air ...

Air Outlet Damper Control Servo Motor Circuit (B1443/43)
DESCRIPTION This No. 1 air conditioning radiator damper servo sub-assembly (for mode switching) is controlled by the air conditioning amplifier assembly and moves the mode damper to the desired p ...

Other materials:

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use these procedure to troubleshoot the seat belt warning system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT 2 ...

Transmission Fluid Temperature Sensor "A" Circuit Low Input (P0712,P0713)
DESCRIPTION The No. 1 ATF temperature sensor converts the fluid temperature into a resistance value for use by the ECM. The ECM applies a voltage to the temperature sensor through terminal THO1 of the ECM. The sensor resistance changes with the ATF temperature. As the temperature becomes hi ...

Removal
REMOVAL PROCEDURE 1. DRAIN TRANSFER OIL 2. REMOVE FRONT PROPELLER SHAFT ASSEMBLY 3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY 4. SUPPORT TRANSMISSION ASSEMBLY 5. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY 6. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR 7. SUPPO ...

В© 2011-2026 Copyright www.ttguide.net