DESCRIPTION
If the forward recognition camera detects a malfunction in the camera heater (forward recognition hood) circuit, it will output a malfunction signal to the millimeter wave radar sensor assembly via CAN communication and DTC C1AAE will be stored.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
C1AAE |
Heater Circuit |
When the ignition switch is ON, the millimeter wave radar sensor assembly receives a camera heater (forward recognition hood) circuit malfunction signal from the forward recognition camera continuously for 5 seconds or more. |
Forward recognition camera system |
PROCEDURE
|
1. |
GO TO FORWARD RECOGNITION CAMERA SYSTEM |
HINT:
If DTC C1AAE is output by the pre-collision system, perform troubleshooting for the forward recognition camera system.
Click here
| NEXT | |
END |
Vehicle Control History
Lost Communication with ECM / PCM "A" (U0100,U0125,U0126,U0129)Image from Camera for Rear View Monitor is Abnormal
DESCRIPTION
The display signal of the rear television camera assembly is transmitted to the
radio and display receiver assembly*1 or navigation receiver assembly*2.
*1: w/o Navigation System
*2: w/ Navigation System
WIRING DIAGRAM
PROCEDURE
1.
CONFIRM ...
Neutral Position Switch
Components
COMPONENTS
ILLUSTRATION
*1
NEUTRAL POSITION SWITCH
*2
GASKET
N*m (kgf*cm, ft.*lbf): Specified torque
●
Non-reusable part
Installation
INSTALLATION
PROCEDURE
1. INSTALL NEUTR ...
Initialization
INITIALIZATION
1. INITIALIZE SLIDING ROOF SYSTEM
NOTICE:
Before starting this operation, make sure that the guide rails are not
deformed and there is no foreign matter on the guide rails.
When the sliding roof glass sub-assembly or sliding roof drive cable
sub-assembly is adju ...