DESCRIPTION
These DTCs are stored when a malfunction occurs in the radio and display receiver assembly.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
B1551 |
When one of the conditions below is met:
|
Radio and display receiver assembly |
|
B158D |
The internal video signal of the radio and display receiver assembly is interrupted. |
|
|
B15A0 |
When either condition below is met:
|
|
|
B15B0 |
Picture circuit (TFT unit) malfunction |
|
|
B15B3 |
When one of the conditions below is met:
|
|
|
B15B4 |
When one of the conditions below is met:
|
|
|
B15B7 |
"Bluetooth" module malfunction |
PROCEDURE
|
1. |
CHECK DTC |
(a) Clear the DTCs (See page
).
(b) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
| OK | |
USE SIMULATION METHOD TO CHECK |
| NG | |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
LVDS Signal Malfunction (from Extension Module) (B1532)
Extension Module Malfunction (B1552,B158A,B15BA)Acceleration Sensor Internal Circuit (C1419,C1435)
DESCRIPTION
The skid control ECU (master cylinder solenoid) receives signals from the yaw
rate and acceleration (airbag sensor assembly) via the CAN communication system.
The airbag sensor assembly has a built-in yaw rate and acceleration sensor and
detects the vehicle's condition using 2 ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT REAR AIRBAG SENSOR (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check (See page
).
2. INSPECT REAR AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag has
not Deployed)
CAUTION:
For rear airbag sensor removal and ...
Fuel information
Your vehicle must use only unleaded gasoline.
Select octane rating 87 (Research Octane Number 91) or higher. Use of unleaded
gasoline with an octane rating lower than 87 may result in engine knocking. Persistent
knocking can lead to engine damage.
At minimum, the gasoline you use should meet t ...