Toyota Tacoma (2015-2018) Service Manual: Extension Module Malfunction (B1552,B158A,B15BA)

Toyota Tacoma (2015-2018) Service Manual / Audio / Video / Audio And Visual System / Extension Module Malfunction (B1552,B158A,B15BA)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the stereo component tuner assembly.

DTC No.	DTC Detection Condition	Trouble Area
B1552	Internal malfunction of the navigation ECU	Stereo component tuner assembly
B158A	Screen noise adjustment fails
B15BA	When either of the following conditions is met: Internal IC malfunction Tuner malfunction

CAUTION / NOTICE / HINT

NOTICE:

After replacing the stereo component tuner assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.

PROCEDURE

CHECK DTC

(a) Clear the DTCs (See page (b) Recheck for DTCs and check that no DTCs are output. ).

(b) Recheck for DTCs and check that no DTCs are output.

OK:

No DTCs are output.

USE SIMULATION METHOD TO CHECK

REPLACE STEREO COMPONENT TUNER ASSEMBLY

HD Radio Tuner Malfunction (B1551,B158D,B15A0,B15B0,B15B3,B15B4,B15B7)

DESCRIPTION These DTCs are stored when a malfunction occurs in the radio and display receiver assembly. DTC No. DTC Detection Condition Trouble Area ...

USB Device Malfunction (B1585)

DESCRIPTION This DTC is stored when a malfunction occurs in a connected device. DTC No. DTC Detection Condition Trouble Area B1585 USB De ...

Other materials:

TS and CG Terminal Circuit
DESCRIPTION In Test Mode (signal check), a malfunction in the speed sensor that cannot be detected when the vehicle is stopped can be detected while driving. Sensor check mode can be entered by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON. WIRING D ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE TAIL GATE PROTECTOR (See page ) 2. REMOVE TAIL GATE SERVICE HOLE COVER (a) Using a T30 "TORX" socket wrench, remove the 8 screws and tail gate service hole cover. 3. REMOVE REAR TELEVISION CAMER ...

Engine Immobiliser System Incorrect Assembly (B279C95)
DESCRIPTION This code is stored when an ECM that is incompatible with the engine immobiliser system is installed to the vehicle. DTC Code DTC Detection Condition Trouble Area DTC Output Confirmation Operation B279C95 An ECM ...