Toyota Tacoma (2015-2018) Service Manual: Front Wiper Rubber

Toyota Tacoma (2015-2018) Service Manual / Wiper / Washer / Front Wiper Rubber

Components

COMPONENTS

ILLUSTRATION

Installation

INSTALLATION

PROCEDURE

1. INSTALL FRONT WIPER RUBBER

(a) Install the 2 wiper rubber backing plates to the front wiper rubber.

NOTICE:

Align the groove of the front wiper rubber backing plate with the edge of the wiper rubber.
Make sure that the front wiper rubber backing plate is perpendicular to the glass.

(b) Install the front wiper rubber together with the 2 front wiper rubber backing plates to the front wiper blade.

NOTICE:

Push the front wiper blade into the grooves of the wiper rubber to engage them completely.

HINT:

Install the wiper rubber LH so that the head part (large side) of the wiper rubber faces the arm axis side.

2. INSTALL FRONT WIPER BLADE

(a) Install the front wiper blade to the front wiper arm as shown in the illustration.

Text in Illustration

Holder

(b) Install the holder of the front wiper blade as shown in the illustration.

Removal

REMOVAL

CAUTION / NOTICE / HINT

NOTICE:

Make sure to hold the front wiper arm while lifting it as lifting the front wiper arm by the front wiper blade may damage or deform the front wiper blade

HINT:

The following procedure is for the LH side.
Use the same procedure for the RH side and LH side.

PROCEDURE

1. REMOVE FRONT WIPER BLADE

(a) Remove the holder of the front wiper blade as shown in the illustration.

Text in Illustration

Holder

(b) Remove the front wiper blade from the front wiper arm as shown in the illustration.

NOTICE:

Do not lower the front wiper arm with the front wiper blade removed. The arm tip may damage the windshield surface.

2. REMOVE FRONT WIPER RUBBER

(a) Remove the front wiper rubber with wiper rubber backing plates from the front wiper blade.

(b) Remove the 2 wiper rubber backing plates from the front wiper rubber.

Removal

REMOVAL PROCEDURE 1. REMOVE FRONT WIPER ARM HEAD CAP (a) Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws to remove the front wiper arm head cap. ...

Washer Level Warning Switch

Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT LEVEL WARNING SWITCH ASSEMBLY HINT: This check should be performed with the windshield washer motor and pump ...

Other materials:

Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedures for both the LH and RH sides. The procedure described below is for the LH side. PROCEDURE 1. REMOVE OUTER MIRROR (a) Push the lower part of the mirror surface and tilt it. Text in Illustration ...

Freeze Frame Data
FREEZE FRAME DATA 1. FREEZE FRAME DATA (a) When a DTC is stored, the 4 wheel drive control ECU stores the current vehicle state as Freeze Frame Data. HINT: Freeze Frame Data at the time a DTC is stored: When the 4 wheel drive control ECU stores data at the time a DTC is stored, no updates w ...

Pressure Control Solenoid "B" Performance (Shift Solenoid Valve SL2) (P0776)
SYSTEM DESCRIPTION The ECM uses the vehicle speed signal and signals from the transmission revolution sensors (NT, SP2) to detect the actual gear (1st, 2nd, 3rd, 4th, 5th or 6th gear). The ECM compares the actual gear with the shift schedule in the ECM memory to detect mechanical problems of t ...