DESCRIPTION
This code is stored when an ECM that is incompatible with the engine immobiliser system is installed to the vehicle.
|
DTC Code |
DTC Detection Condition |
Trouble Area |
DTC Output Confirmation Operation |
|---|---|---|---|
|
B279C95 |
An ECM that is incompatible with the engine immobiliser system is installed (1 trip detection logic*). |
ECM |
Check for DTCs. |
|
Vehicle Condition when Malfunction Detected |
Fail-safe Operation when Malfunction Detected |
|---|---|
|
Engine cannot be started |
- |
|
DTC Code |
Data List and Active Test |
|---|---|
|
B279C95 |
- |
PROCEDURE
|
1. |
CLEAR DTC |
(a) Clear the DTCs (See page
).
|
|
2. |
CHECK FOR DTC |
(a) Check for DTCs (See page
).
OK:
DTC B279C95 is not output.
| OK | |
USE SIMULATION METHOD TO CHECK |
| NG | |
REPLACE ECM |
Diagnostic Trouble Code Chart
Antenna Coil Open / Short (B2784)On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT FRONT AXLE HUB BEARING
(a) Remove the front wheel.
(b) for 4WD:
(1) Remove the front axle hub grease cap (See page
).
(c) Remove the front disc brake caliper (See page
).
(d) Remove the front disc.
(e) Inspect the axle hub backlash.
(1) Usi ...
Yaw Rate Sensor Malfunction (C1436)
DESCRIPTION
The skid control ECU (brake actuator assembly) receives signals from the yaw
rate and acceleration sensor (airbag sensor assembly) via the CAN communication
system.
The airbag sensor assembly has a built-in yaw rate sensor and detects the vehicle
condition.
If there is trouble i ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table. Check each sy ...