DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
- Use the same procedures for both the LH and RH sides.
- The procedure described below is for the LH side.
PROCEDURE
1. REMOVE OUTER MIRROR
(a) Push the lower part of the mirror surface and tilt it.
Text in Illustration
.png) |
Protective Tape |
.png) |
Push |
(b) Apply protective tape to the area shown in the illustration.
(c) Push the upper part of the mirror surface and tilt it.
Text in Illustration
| |
Protective Tape |
| |
Push |
(d) Apply protective tape to the area shown in the illustration.
|
(e) Using a moulding remover D, disengage the 2 claws on the lower part of the outer mirror. |
|
(f) Push the lower part of the mirror surface.
HINT:
If excessive force is used when pressing down the mirror surface, the 2 claws will engage again.
|
(g) Using a moulding remover D, disengage the 2 claws on the upper part of the outer mirror. |
|
(h) Remove the protective tape.
|
(i) Disengage the clamp. |
|
(j) Disconnect the 3 connectors to remove the outer mirror.
NOTICE:
- Do not bend the tabs excessively to prevent them from being damaged.
- If the tabs are damaged, replace the outer mirror with a new one.
- If the wire harness is damaged or any of the wires are broken, replace the outer rear view mirror assembly with a new one.
2. REMOVE OUTER MIRROR COVER (w/o Side Turn Signal Light)
|
(a) Disengage the 8 claws to remove the outer mirror cover. |
|
3. REMOVE OUTER MIRROR COVER (w/ Side Turn Signal Light)
|
(a) Disengage the 7 claws to remove the outer mirror cover. |
|
4. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY (w/ Side Turn Signal Light)
.gif)
