DIAGNOSTIC TROUBLE CODE CHART
Audio and Visual System|
DTC Code |
Detection Item |
See page |
|---|---|---|
|
B1324 |
Lost Communication with Meter |
|
|
B1532 |
LVDS Signal Malfunction (from Extension Module) |
|
|
B1551 |
HD Radio Tuner Malfunction |
|
|
B1552 |
Extension Module Malfunction |
|
|
B1579 |
Voice Recognition Microphone Disconnected |
|
|
B1585 |
USB Device Malfunction |
|
|
B158A |
Extension Module Noise Adjustment Malfunction |
|
|
B158D |
Video Signal Stoppage |
|
|
B158F |
AV Signal Stoppage (Low Battery Voltage) |
|
|
B15A0 |
LAN Master Malfunction |
|
|
B15B0 |
Display Screen Malfunction |
|
|
B15B3 |
Radio Tuner Malfunction |
|
|
B15B4 |
CD Changer Malfunction |
|
|
B15B7 |
Bluetooth Module Malfunction |
|
|
B15BA |
XM Tuner Malfunction |
|
|
B15C0 |
Short in GPS Antenna |
|
|
B15C1 |
Open in GPS Antenna |
|
|
B15C3 |
Speaker Output Short |
|
|
B15F5 |
A/C ECU Vehicle Information Reading/Writing Processor Malfunction |
|
|
B15F6 |
Main Body ECU Vehicle Information Reading/Writing Process Malfunction |
|
|
B15F7 |
Certification ECU Vehicle Information Reading/Writing Process Malfunction |
|
|
B15FE |
XM Tuner Antenna Disconnected |
|
|
B15FF |
XM Tuner Antenna Short |
|
|
U0073 |
Sending Malfunction (Navigation to APGS) |
|
|
U0100 |
Lost Communication with ECM |
|
|
U0140 |
Lost Communication with Body Control Module |
|
|
U0155 |
Meter ECU Communication |
|
Dtc Check / Clear
Lost Communication with Meter (B1324)Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT BUMPER ASSEMBLY
(a) w/ Fog Light:
(1) Connect the 2 connectors.
(b) Engage the 3 claws and guide to install the front bumper assembly.
(c) Remove the protective tape.
(d) Install the 6 clips.
(e) Engage the clamp.
(f) Connect the connector.
(g) Insta ...
Freeze Frame Data
FREEZE FRAME DATA
DESCRIPTION
(a) Whenever a lane departure alert system is stored, the forward recognition
camera stores the current vehicle state (ECU and sensor information) as Freeze Frame
Data.
CHECK FREEZE FRAME DATA
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch ...
4wd Control Ecu
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL 4 WHEEL DRIVE CONTROL ECU
(a) Engage the 2 guides to install the 4 wheel drive control ECU.
(b) Install the 2 bolts.
Torque:
5.0 N·m {51 kgf·cm, 44 in·lbf}
(c) Connect the 2 connectors.
2. INSTALL ...