Toyota Tacoma (2015-2018) Service Manual: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM|
DTC Code |
Detection Item |
See page |
|---|---|---|
|
P163B |
4WD ECU Malfunction |
|
|
P17A0 |
Automatic Disconnecting Differential Motor Control Circuit Open |
|
|
P17A4 |
Automatic Disconnecting Differential Motor Limit Switch Circuit |
|
|
P17A8 |
Transfer Shift Motor Control Circuit Circuit Open |
|
|
P17A9 |
Transfer Shift Motor Control Circuit Low |
|
|
P17AA |
Transfer Shift Motor Control Circuit High |
|
|
P17AC |
Transfer Shift Motor Limit Switch Circuit |
|
|
P17C7 |
Front Differential Oil Temperature Sensor Circuit Low |
|
|
P17C8 |
Front Differential Oil Temperature Sensor Circuit High |
|
|
P2772 |
Four Wheel Drive (4WD) Low Switch Circuit Range / Performance |
|
|
P279E |
Four Wheel Drive (4WD) Range Signal Circuit Range / Performance |
|
|
U0100 |
Lost Communication with ECM / PCM "A" |
|
|
U0122 |
Lost Communication with Vehicle Dynamics Control Module |
|
|
U0416 |
Invalid Data Received From Vehicle Dynamics Control Module |
|
.gif)
Freeze Frame Data
FREEZE FRAME DATA
1. FREEZE FRAME DATA
(a) When a DTC is stored, the 4 wheel drive control ECU stores the current vehicle
state as Freeze Frame Data.
HINT:
Freeze Frame Data at the time a DTC is ...
Front Differential Oil Temperature Sensor Circuit Low (P17C7)
DESCRIPTION
This DTC is output when a short to ground in the oil temperature sensor is detected.
DTC No.
Detection Item
DTC Detection Condition
Trouble Ar ...
Other materials:
ABS Warning Light does not Come ON
DESCRIPTION
Refer to ABS Warning Light Remains ON (See page
).
WIRING DIAGRAM
Refer to ABS Warning Light Remains ON (See page
).
CAUTION / NOTICE / HINT
NOTICE:
When replacing the skid control ECU (master cylinder solenoid), perform
calibration (See page
).
Inspect the ...
Front Passenger Side Seat Heater does not Operate
DESCRIPTION
When the seat heater switch on the air conditioning control assembly is operated,
the air conditioning amplifier assembly receives the signal. The air conditioning
amplifier assembly receives the signal and operates the front seat heater.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL STARTER ARMATURE ASSEMBLY
(a) Install the starter armature to the starter yoke.
2. INSTALL STARTER BRUSH HOLDER ASSEMBLY
(a) Install the starter brush holder assembly.
(b) Connect the 4 brushes to the starter brush holder assembly.
(1) Using a scre ...
