Toyota Tacoma (2015-2018) Service Manual: Diagnosis System
DIAGNOSIS SYSTEM
1. DIAGNOSIS
(a) If the skid control ECU (master cylinder solenoid) detects a malfunction, the ABS and/or BRAKE warning lights and the slip indicator lights come on in accordance with the trouble area to warn the driver.
HINT:
- The DTCs are simultaneously stored in the memory. The DTCs can be read by connecting the Techstream.
- This system has a Test Mode sensor signal check function. Test mode DTCs can be read by connecting the Techstream and observing the blinking pattern of the ABS warning light and slip indicator light.
NOTICE:
If parts connected to the IG terminal circuit are damaged due to high voltage, DTCs may not be able to be output from the ABS warning light and slip indicator light by connecting SST to the DLC3. In this case, inspect the IG power source circuit.
2. WARNING LIGHT AND INDICATOR LIGHT CHECK
(a) Release the parking brake.
CAUTION:
When releasing the parking brake, set chocks to hold the vehicle for safety.
HINT:
When the parking brake is applied or the level of the brake fluid is low, the BRAKE warning light comes on.
(b) Check that the ABS warning light, BRAKE warning light and slip indicator light come on when the ignition switch is turned to ON, and go off in approximately 3 seconds.
HINT:
If the indicator remains on or does not come on, proceed to troubleshooting for the light circuit below.
|
Trouble Area |
See Page |
|---|---|
|
ABS warning light circuit (Remains on) |
|
|
ABS warning light circuit (Does not come on) |
|
|
BRAKE warning light circuit (Remains on) |
|
|
BRAKE warning light circuit (Does not come on) |
|
|
Slip indicator light circuit (Remains on) |
|
|
Slip indicator light circuit (Does not come on) |
|
.gif)
Terminals Of Ecu
TERMINALS OF ECU
1. TERMINALS OF ECU
Text in Illustration
*a
Component without harness connected
(Skid Control ECU (Master Cylinder Solenoid))
-
-
...
Dtc Check / Clear
DTC CHECK / CLEAR
1. DTC CHECK / CLEAR (when Using Techstream)
(a) Check for DTCs.
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Ent ...
Other materials:
Pressure Control Solenoid "B" Electrical (Shift Solenoid Valve SL2) (P0778)
DESCRIPTION
Changing from 1st to 6th is performed by the ECM turning shift solenoid valves
SL1, SL2, SL3 and SL4 on and off. If an open or short circuit occurs in any of the
shift solenoid valves, the ECM controls the remaining normal shift solenoid valves
to allow the vehicle to be operated ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY
(a) Before installing the rear seat 3 point type outer belt assembly,
check the ELR function.
Text in Illustration
*a
Unlock
*b
...
Tachometer Malfunction
DESCRIPTION
In this circuit, the meter CPU receives engine speed signals from the ECM using
the CAN communication system (CAN V1 Bus). The meter CPU displays the engine speed
calculated based on the data received from the ECM.
WIRING DIAGRAM
PROCEDURE
1.
CHECK CAN CO ...
