DESCRIPTION
The airbag sensor assembly consists of a deceleration sensor, safing sensor, drive circuit, diagnosis circuit, ignition control, etc.
If the airbag sensor assembly receives signals from the deceleration sensor, it determines whether or not the SRS should be activated.
DTC B1000/31 is set when a malfunction is detected in the airbag sensor assembly.
|
DTC No. |
DTC Detecting Condition |
Trouble Area |
|---|---|---|
|
B1000/31 |
Airbag sensor assembly malfunction |
Airbag sensor assembly |
HINT:
When any other DTCs are set simultaneously with B1000/31, repair the malfunctions indicated by those DTCs first.
PROCEDURE
|
1. |
CHECK DTC |
(a) Check for DTCs (See page
).
|
Result |
Proceed to |
|---|---|
|
DTC B1000/31 is output |
A |
|
DTC B1000/31 and other DTCs are output |
B |
NOTICE:
If only DTC B1000/31 is output, do not clear the DTCs, replace the airbag sensor assembly.
HINT:
If any DTCs other than DTC B1000/31 are also output, troubleshoot those DTCs first.
| A | |
REPLACE AIRBAG SENSOR ASSEMBLY |
| B | |
GO TO DIAGNOSTIC TROUBLE CODE CHART |
Rear Airbag Sensor LH Circuit Malfunction (B1635/24)
Front Airbag Sensor LH Circuit Malfunction (B1615/14)Components
COMPONENTS
ILLUSTRATION
*1
LOWER NO. 2 STEERING WHEEL COVER
*2
LOWER NO. 3 STEERING WHEEL COVER
*3
STEERING PAD
-
-
N*m (kgf*cm, ft.*lbf): Specified torque
-
...
Inspection
INSPECTION
PROCEDURE
1. INSPECT NO. 1 ULTRASONIC SENSOR
(a) Measure the resistance according to the value(s) in the table below.
Text in Illustration
*a
Component without harness connected:
(No. 1 Ultrasonic Sensor)
Standar ...
Center Airbag Sensor Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Center Airbag Sensor Communication Stop Mode
Either condition is met:
Communication stop for "Airbag" is indicated on the "Communication
Bus Check" sc ...