Toyota Tacoma (2015-2018) Service Manual: Data List / Active Test
DATA LIST / ACTIVE TEST
HINT:
By accessing the Data List displayed on the Techstream, you can perform such functions as reading the values of switches and sensors without removing any parts. Reading the Data List is the first step of troubleshooting and is one method to shorten labor time.
1. DATA LIST FOR AIRBAG SENSOR ASSEMBLY
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON and turn the Techstream on.
(c) Follow the display on the Techstream screen to enter the "Data List".
(d) Check the condition by referring to the table below.
|
Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|
|
Driver Seat Position |
Seat position (Driver side)/ Forward: Seat position is forward Bkward: Seat position is rearward Fail: A failure is detected |
Forward/Bkward |
- |
|
Passenger Classification |
Passenger classification/ NG: Data is not determined OFF: Vacant Child: Child is seated or vacant AF05: Adult is seated AM50: Adult is seated Fail: Failure is detected |
OFF/Child/AF05/AM50 |
- |
|
Left side Buckle SW |
Buckle switch (Driver side)/ Unset: The seat belt is not fastened Set: The seat belt is fastened NG: Data is not determined |
Unset/Set |
- |
|
Right side Buckle SW |
Buckle switch (Right side)/ Unset: The seat belt is not fastened Set: The seat belt is fastened NG: Data is not determined |
Unset/Set |
- |
|
Display Type Information |
Display type identification information/ LR: The display is indicated by LH/RH DP: The display is indicated by Driver/Passenger |
DP |
- |
|
Number of Past DTC |
Min.: 0, Max.: 255 |
0 |
- |
Terminals Of Ecu
TERMINALS OF ECU
1. AIRBAG SENSOR ASSEMBLY
Terminal No.
Terminal Symbol
Destination
A21-1
P2+
Instrument panel passenger wit ...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
If a DTC is displayed during the DTC check, check the circuit listed for the
DTC in the table below (refer to the appropriate page).
HINT:
When the SRS warni ...
Other materials:
Input/Turbine Speed Sensor "A" Circuit Short to Battery (P071512,P071514,P071531)
DESCRIPTION
This sensor detects the rotation speed of the turbine which shows the input turbine
speed of the transmission. By comparing the input turbine speed signal (NT) with
the output shaft speed sensor signal (SP2), the ECM detects the shift timing of
the gears and appropriately controls ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT OIL CLEARANCE
(a) Using a micrometer and caliper gauge, measure the oil seal clearance.
Text in Illustration
*1
Pulley Shaft
*2
Front Vane Pump Housing
...
CD cannot be Ejected
PROCEDURE
1.
CHECK OPERATION
(a) Press the disc eject switch of the radio and display receiver assembly for
5 seconds or more and check that the CD is ejected.
OK:
CD is ejected.
NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY
...
