General Maintenance
GENERAL MAINTENANCE
PROCEDURE
1. GENERAL NOTES
2. WINDSHIELD WASHER FLUID
(a) Check if there is sufficient fluid in the tank.
3. ENGINE COOLANT LEVEL
(a) Check if the coolant level is between the "FULL" and "LOW" lines on the see-through reservoir.
4. RADIATOR AND HOSES
(a) Check if the front of the radiator is clean and not blocked by leaves, dirt or bugs.
(b) Check the hoses for cracks, kinks, rot or loose connections.
5. BATTERY ELECTROLYTE LEVEL
(a) Check if the electrolyte level of all the battery cells is between the upper and lower level lines on the case.
6. BRAKE FLUID LEVEL
(a) Check if the brake fluid levels are near the upper level line on the see-through reservoirs.
7. ENGINE DRIVE BELT
(a) Check the drive belt for fraying, cracks, wear or oiliness.
8. ENGINE OIL LEVEL
(a) Check the level on the dipstick with the engine turned off.
9. POWER STEERING FLUID LEVEL
(a) Check the level on the dipstick.
(b) The level should be in the "HOT" or "COLD" range depending on the fluid temperature.
10. AUTOMATIC TRANSMISSION FLUID LEVEL
(a) Visually check the overflow plug and oil pan for fluid leaks or traces of fluid.
11. EXHAUST SYSTEM
(a) If any change in the sound of the exhaust or the smell of the exhaust fumes is noticed, locate and correct the cause.
Starting System
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs depending on the specifications
of the vehicle. The expressions listed in the table below are used in this section. ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
If one of the camshaft timing gear bolts is already removed, do not remove any
other camshaft timing gear bolts.
PROCEDURE
1. REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Off Road Package)
2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
3. REMOVE ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 1 ULTRASONIC SENSOR
HINT:
Use the same procedure for both sides.
(a) Engage the 4 claws to install the 4 No. 1 ultrasonic sensors as shown in
the illustration.
2. INSTALL REAR BUMPER EXTENSION LH (w/ Towing Package)
(See page )
3. INSTALL REAR BUMPE ...