General Maintenance
GENERAL MAINTENANCE
CAUTION / NOTICE / HINT
Performing these maintenance checks on the vehicle is the owner's responsibility. The owner may perform the maintenance or take the vehicle to a service center.
Check the parts of the vehicle described below on a daily basis. In most cases, special tools are not required. It is recommended that the owner perform these checks.
The procedures for general maintenance are as follows.
PROCEDURE
1. GENERAL NOTES
2. TIRES
(a) Check the tire pressure with a gauge. Make adjustments if necessary.
(b) Check the surfaces of tires for cuts, damage or excessive wear.
3. WHEEL NUTS
(a) Check for nuts that are loose or missing. Tighten them if necessary.
4. TIRE ROTATION
(a) Check the maintenance schedule in the owner's manual supplement.
5. WINDSHIELD WIPER BLADES
(a) Check the blades for wear or cracks when they are unable to wipe the windshield clean. Replace them if necessary.
6. FLUID LEAKS
(a) Check under the vehicle for leaking fuel, oil, water and other fluids.
(b) If you smell gasoline fumes or notice any leaks, locate the cause and correct it.
7. DOORS AND ENGINE HOOD
(a) Check if all of the doors and the tailgate operate smoothly and if all the latches lock securely.
(b) When the primary latch is released, check if the engine hood secondary latch prevents the hood from opening.
Fuel Receiver Gauge Malfunction
DESCRIPTION
The meter CPU uses the fuel sender gauge assembly to determine the level of the
fuel in the fuel tank. The resistance of the fuel sender gauge will vary between
approximately 13.5 Ω with the float at the full position, and 414.5 Ω with the float
at the empty position. The meter ...
Removal
REMOVAL
PROCEDURE
1. REMOVE FUEL PUMP ASSEMBLY (for High Pressure)
(See page )
2. REMOVE NO. 2 FUEL PIPE SUB-ASSEMBLY
(a) Loosen the 2 union nuts and remove the No. 2 fuel pipe sub-assembly from
the fuel delivery pipe RH and fuel delivery pipe sub-assembly LH.
Text in Illustration
...
Initialization
INITIALIZATION
1. RESET MEMORY
NOTICE:
Perform Reset Memory (AT initialization) when replacing the automatic
transmission assembly, transmission valve body assembly or any of the shift
solenoid valves.
Reset Memory can be performed only with the Techstream.
HINT:
The E ...