INSTALLATION
PROCEDURE
1. INSTALL NO. 1 ULTRASONIC SENSOR
HINT:
Use the same procedure for both sides.
(a) Engage the 4 claws to install the 4 No. 1 ultrasonic sensors as shown in the illustration.
2. INSTALL REAR BUMPER EXTENSION LH (w/ Towing Package)
(See page )
3. INSTALL REAR BUMPER EXTENSION LH (w/o Towing Package)
(See page )
4. INSTALL REAR BUMPER EXTENSION RH (w/ Towing Package)
HINT:
Use the same procedure as for the LH side.
5. INSTALL REAR BUMPER EXTENSION RH (w/o Towing Package)
HINT:
Use the same procedure as for the LH side.
6. INSTALL REAR BUMPER PAD SUB-ASSEMBLY (w/ Towing Package)
(See page )
7. INSTALL REAR BUMPER PAD SUB-ASSEMBLY (w/o Towing Package)
(See page )
8. INSTALL CONNECTOR COVER (w/ Towing Package)
(See page )
9. INSTALL REAR BUMPER HOLE COVER (w/o Towing Package)
(See page )
10. INSTALL REAR BUMPER ASSEMBLY (w/ Towing Package)
(See page )
11. INSTALL REAR BUMPER ASSEMBLY (w/o Towing Package)
(See page )
Clearance Warning ECU Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Clearance Warning ECU Communication Stop Mode
Either Condition is met:
Communication stop for "Clearance Warning (Intuitive Parking
Assist1)" is indicated on th ...
Precaution
PRECAUTION
1. EXPRESSIONS OF IGNITION SWITCH
HINT:
The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch
(Position)
...
Lost Communication with ECM/PCM "A" Missing Message (U010087)
DESCRIPTION
The engine control unit and the transmission control unit are located inside
the ECM. The engine control unit intercommunicates with the transmission control
unit with the Controller Area Network (CAN).
If there is a problem in this intercommunication, the ECM stores a DTC.
...