SYSTEM DESCRIPTION
LANE DEPARTURE ALERT SYSTEM DESCRIPTION
(a) The lane departure alert system is a system which uses the forward recognition camera to recognize and determine the lane and the position of the vehicle when the vehicle is being driven on highways and other roads with white (yellow) lines. Based on the situation, this system provides information and warnings for the driver.
SYSTEM SPECIFICATION
Operation speed |
Approximately 50 km/h (32 mph) or more. |
Operation lane width |
Approximately 3 m (10 ft.) or more. |
Operation curve radius |
Approximately 150 m (493 ft.) or more. |
OPERATING CONDITIONS
(a) Lane departure alert function can operate if all of the following base conditions are met:
(b) Vehicle sway warning can operate if all of the following base conditions are met:
CONTROL OF EACH FUNCTION
(a) Lane departure alert function:
(1) Sensitivity: "Standard (graphic display)"
A warning is output when a front wheel starts to cross a lane marker.
HINT:
When the deviation speed (lateral travel speed) is slow, the warning may be output after the front wheel crosses over the lane marker.
(2) Sensitivity: "High (graphic display)"
A warning is provided when a front wheel nears a lane marker.
HINT:
When the deviation speed (lateral travel speed) is slow, the warning may be provided when the front wheel starts to cross the lane marker.
(b) Vehicle sway warning:
(1) A warning is output when any of the following occurs:
FUNCTION OF COMPONENTS
COMPONENTS |
FUNCTION |
---|---|
*1: for Vacuum Brake Booster
*2: for Hydraulic Brake Booster |
|
Forward Recognition Camera |
|
Lane Departure Alert Main Switch (Steering Pad Switch Assembly) |
Turns on/off the lane departure alert system |
Customize Switch (Steering Pad Switch Assembly) |
Changes the customize settings of the lane departure warning function and vehicle sway warning function |
Combination Meter Assembly |
|
Spiral Cable with Sensor Sub-assembly |
Sends the turning angle of the steering wheel to the forward recognition camera |
|
Sends the wheel speed, yaw rate zero point, brake operation status and other information to the forward recognition camera |
Yaw Rate and Acceleration Sensor (Airbag Sensor Assembly) |
Sends signals received from the yaw rate and acceleration sensor to the forward recognition camera |
ECM |
Sends the accelerator pedal opening angle signal to the forward recognition camera |
Millimeter Wave Radar Sensor Assembly |
Sends the preceding vehicle information to the forward recognition camera |
Main Body ECU (Multiplex Network Body ECU) |
Sends the country specification information to the forward recognition camera |
Network Gateway ECU |
Gateway function of CAN communication |
SYSTEM INOPERATIVE CONDITIONS
(a) The lane departure alert system may not operate in any of the following conditions:
Precaution
PRECAUTION
CAUTION:
The vehicle is equipped with SRS, which consists of a driver airbag,
front passenger airbag, side airbags and curtain shield airbags and knee
airbags. Failure to carry out service operations in the correct sequence
could cause the SRS to unexpectedly deploy ...
Fuel Sender Open Detected (B1500)
DESCRIPTION
This DTC is output when the combination meter assembly detects a fuel sender
gauge assembly malfunction.
DTC No.
DTC Detection Condition
Trouble Area
B1500
When either of the following conditions is detected:
...
Front Passenger Side Door ECU Communication Stop (B2322)
DESCRIPTION
This DTC is stored when LIN communication between the front power window regulator
motor assembly RH and main body ECU (multiplex network body ECU) stops for 10 seconds
or more.
DTC No.
DTC Detection Condition
Trouble Area
B2322
...