Toyota Tacoma (2015-2018) Service Manual: Smart Key System(for Entry Function)
- Parts Location
- Precaution
- System Diagram
- How To Proceed With Troubleshooting
- System Description
- Customize Parameters
- Operation Check
- Problem Symptoms Table
- Diagnosis System
- Terminals Of Ecu
- Diagnostic Trouble Code Chart
- Dtc Check / Clear
- Operation History List
- Open in Driver Side Electrical Antenna Circuit (B27A1)
- Open in Rear Floor Electrical Key Oscillator Circuit (B27A6)
- All Door Entry Lock/Unlock Functions do not Operate, but Wireless Functions Operate
- Open in Front Floor Electrical Key Oscillator Circuit (B27A5)
- Driver Side Door Entry Lock and Unlock Functions do not Operate
- Driver Side Door Entry Unlock Function does not Operate
- Driver Side Door Entry Lock Function does not Operate
- Entry Interior Alarm does not Sound
- Room Oscillator does not Recognize Key
- Additional Key cannot be Registered
- New Key cannot be Registered
- Entry Exterior Alarm and Answer-back Buzzer do not Sound
All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch
DESCRIPTION
The main body ECU (multiplex network body ECU) receives switch signals from the
door control switch assembly on the front passenger door and activates the door
lock motor on each door ...
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Other materials:
Precaution
PRECAUTION
1. HANDLING PRECAUTIONS FOR STEERING SYSTEM
(a) Care must be taken when replacing parts. Incorrect replacement could affect
the performance of the steering system and result in driving hazards.
2. HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM
(a) The vehicle is equipped with SRS (Suppl ...
Reservoir Level Switch Disconnected (C1453,C1454)
DESCRIPTION
The brake fluid level warning switch sends the appropriate signal to the skid
control ECU (master cylinder solenoid) when the brake fluid level drops.
DTC Code
DTC Detection Condition
Trouble Area
C1453
With the ECU termina ...
Disassembly
DISASSEMBLY
PROCEDURE
1. INSPECT CONNECTING ROD THRUST CLEARANCE
(a) Using a dial indicator, measure the thrust clearance while moving
the connecting rod back and forth.
Standard thrust clearance:
0.15 to 0.40 mm (0.00591 to 0.0157 in.)
Maximum thrust clearance:
0.50 ...
