REMOVAL
PROCEDURE
1. REMOVE FUEL DELIVERY PIPE ASSEMBLY LH (FUEL PRESSURE SENSOR)
(See page )
NOTICE:
2. REMOVE FUEL PIPE PLUG SUB-ASSEMBLY
(a) Secure the fuel delivery pipe assembly LH in a vise between aluminum plates.
NOTICE:
Do not overtighten the vise.
(b) Remove the dust cap sub-assembly from the fuel pipe plug sub-assembly.
(c) Using a 5 mm hexagon wrench, remove the 2 bolts and fuel pipe plug sub-assembly. |
|
(d) Remove the gasket from the fuel pipe plug sub-assembly.
(e) Remove the O-ring, No. 3 fuel injector back-up ring, No. 2 fuel injector back-up ring and No. 1 fuel injector back-up ring from the fuel pipe plug sub-assembly. Text in Illustration
|
|
(f) Remove the fuel delivery pipe assembly LH from the vise.
Operation Check
OPERATION CHECK
1. NOTICE WHEN CHECKING THE FOLLOWING
(a) Wireless door lock/unlock function:
This wireless door lock control function operates only when the following 3 conditions
are met:
(1) There is no key in the ignition key cylinder.
(2) All doors are closed.
(3) The power door lock sy ...
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting
the cable from the negative (-) battery terminal. Therefore, make sure to read the
disconnecting the cable from the negative (-) battery terminal notices before pr ...
Side Moulding
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
When removing the lower No. 2 side panel moulding, heat the vehicle
body a ...