INSPECTION
PROCEDURE
1. INSPECT FUEL DELIVERY PIPE SUB-ASSEMBLY LH (FUEL PRESSURE SENSOR)
NOTICE:
(a) Remove the fuel delivery pipe sub-assembly LH (See page ).
(b) Check the fuel pressure sensor output voltage.
(1) Apply 5 V between terminals 1 (VC) and 2 (E2). Text in Illustration
NOTICE:
HINT: If a stable power supply is not available, use 4 1.2 V nickel-metal hydride batteries or equivalent. |
|
(2) Measure the voltage between terminals. Text in Illustration
Standard Voltage:
*: The output voltage changes depending on the voltage applied to the terminals. Output voltage = (0.08 x Voltage applied to terminals) to (0.12 x Voltage applied to terminals) If the result is not as specified, replace the fuel delivery pipe sub-assembly LH. |
|
(c) Install the fuel delivery pipe sub-assembly LH (See page ).
Manual transmission
■ Shifting the shift lever
6-speed models
Fully depress the clutch pedal before operating the shift lever, and then release
it slowly.
5-speed models
Fully depress the clutch pedal before operating the shift lever, and then release
it slowly.
■Maximum allowable speed
Obse ...
Motor Malfunction (C1427)
DESCRIPTION
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1427
Motor Malfunction
Actuator pump motor does not operate properly.
Brake actuator assembly (Ground circuit)
Brak ...
Torque Converter Clutch Pressure Control Solenoid Control Circuit Electrical
(Shift Solenoid Valve SLU) (P2759)
DESCRIPTION
Refer to the system description for DTC P2757 (See page
).
DTC No.
DTC Detection Condition
Trouble Area
P2759
Open or short is detected in shift solenoid valve SLU circuit for 1 second
or more while driving (1 trip dete ...