REASSEMBLY
PROCEDURE
1. INSTALL FRONT AXLE HUB OIL SEAL
(a) Using a brass bar and a hammer, install a new front axle hub oil seal.
NOTICE:
Do not damage the oil seal.
2. INSTALL FRONT AXLE WITH ABS ROTOR BEARING ASSEMBLY
(a) Using SST and a press, install a new bearing onto the front axle hub.
SST: 09649-17010
3. INSTALL FRONT AXLE HUB
(a) Apply MP grease to a new O-ring.
(b) Install the new O-ring onto the axle hub.
(c) Install the dust cover and axle hub onto the steering knuckle with the 4 bolts.
Torque:
80 N·m {816 kgf·cm, 59 ft·lbf}
4. INSTALL FRONT WHEEL ADJUSTING NUT (for 2WD)
(a) Using SST, install a new front wheel adjusting nut.
SST: 09318-12010
T = 275 N*m{ 2,804 kgf*cm 203 ft.*lbf }
5. INSTALL FRONT AXLE HUB OIL SEAL (for 4WD)
(a) Using SST and a press, install a new front axle hub oil seal.
SST: 09527-17011
SST: 09950-70010
09951-07100
SST: 09951-01000
6. INSTALL KNUCKLE GREASE RETAINER CAP (for 2WD)
(a) Using a brass bar and a hammer, install a new knuckle grease retainer cap.
NOTICE:
Do not damage the knuckle grease retainer cap.
Back-up Light Switch
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT BACK-UP LIGHT SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Text in Illustration
*a
Pushed
...
Inspection
INSPECTION
PROCEDURE
1. INSPECT CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY
(a) Check the operation.
(1) Apply battery voltage between the terminals and check that the plunger
operates.
Text in Illustration
*a
Component without harness con ...
Lost Communication with Blind Spot Monitor Slave Module (U0232)
DESCRIPTION
This DTC is stored when the blind spot monitor sensor LH judges that there is
a communication problem with the blind spot monitor sensor RH.
DTC Code
DTC Detection Condition
Trouble Area
U0232
The blind spot monitor sensor ...