Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR SHOCK ABSORBER
(a) Compress and extend the shock absorber rod and check that there is no abnormal resistance or abnormal sounds during operation.
If there is any abnormality, replace the shock absorber with a new one.
NOTICE:
When disposing of the shock absorber, see DISPOSAL on page .
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR WHEEL
2. REMOVE REAR SHOCK ABSORBER
(a) Support the rear axle housing.
(b) Remove the bolt, nut and washer.
(c) Separate the shock absorber from the rear axle housing.
(d) Remove the nut, 3 cushion retainers, cushion No. 1, cushion No. 3 and shock absorber. |
|
Disposal
DISPOSAL
PROCEDURE
1. DISPOSE OF REAR SHOCK ABSORBER
(a) Fully extend the shock absorber rod.
(b) Using a drill, make a hole in the shaded area of the cylinder as shown in the illustration, to discharge the gas inside.
CAUTION:
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR SHOCK ABSORBER
(a) Install the 3 cushion retainers, cushion No. 1, cushion No. 3 and shock absorber with a new nut.
(b) Install the shock absorber with the bolt, nut and washer. |
|
(c) Fully tighten the nut. Torque: 20 N·m {204 kgf·cm, 15 ft·lbf} |
|
2. INSTALL REAR WHEEL
Torque:
113 N·m {1152 kgf·cm, 83 ft·lbf}
3. STABILIZE SUSPENSION
(a) Jack down the vehicle.
(b) Bounce the vehicle up and down several times to stabilize the suspension.
4. FULLY TIGHTEN REAR SHOCK ABSORBER
(a) Fully tighten the nut.
Torque:
58 N·m {591 kgf·cm, 43 ft·lbf}
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 3 REAR BODY NAME PLATE (for 2GR-FKS)
2. INSTALL NO. 2 REAR BODY NAME PLATE (for 4WD)
3. INSTALL SIDE GATE SUPPORT FEMALE HINGE RH
(a) Engage the claw to install the side gate support female hinge RH.
...
Adjustment
ADJUSTMENT
PROCEDURE
1. PREPARE VEHICLE FOR FOG LIGHT AIMING ADJUSTMENT
(a) Prepare the vehicle:
HINT:
Ensure that there is no damage or deformation to the body around the
fog lights.
Fill the fuel tank.
Make sure that the oil is filled to the specified level.
Make sure ...
FCM Destination Information Uninitialized (C1AAA)
DESCRIPTION
When the forward recognition camera is replaced with a new one, the new forward
recognition camera attempts to store the country specification information received
from the main body ECU (multiplex network body ECU). If the forward recognition
camera cannot store the country speci ...