Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT PCV VALVE SUB-ASSEMBLY
(a) Install a clean hose to the PCV valve sub-assembly.
(b) Check the PCV valve sub-assembly operation.
(1) Blow air into the cylinder head cover sub-assembly LH side and check that air passes through easily. If the result is not as specified, replace the PCV valve sub-assembly.
Text in Illustration
*a |
Clean Hose |
*b |
Cylinder Head Cover Sub-assembly LH Side |
Air |
If the result is not as specified, replace the PCV valve sub-assembly.
CAUTION:
Do not suck air through the valve. Petroleum substances inside the valve are hazardous to your health.
(2) Blow air into the intake air surge tank side and check that air passes through with difficulty.
Text in Illustration
*a |
Clean Hose |
*b |
Intake Air Surge Tank Side |
Air |
If the result is not as specified, replace the PCV valve sub-assembly.
(c) Remove the clean hose from the PCV valve sub-assembly.
Removal
REMOVAL
PROCEDURE
1. REMOVE V-BANK COVER SUB-ASSEMBLY
2. REMOVE NO. 2 SURGE TANK STAY
3. DISCONNECT HEATER HOSE
(a) Disengage the clamp and disconnect the heater hose. |
|
4. DISCONNECT PCV HOSE
(a) Slide the clip and disconnect the PCV hose from the cylinder head cover sub-assembly LH. |
|
5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
(a) Remove the bolt and No. 1 engine cover sub-assembly from the cylinder head cover sub-assembly LH. |
|
6. REMOVE PCV VALVE SUB-ASSEMBLY
(a) Remove the PCV valve sub-assembly from the cylinder head cover sub-assembly LH. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL PCV VALVE SUB-ASSEMBLY
(a) Apply a light coat of engine oil to the O-ring.
(b) Install the PCV valve sub-assembly to the cylinder head cover sub-assembly LH.
Torque:
5.0 N·m {51 kgf·cm, 44 in·lbf}
NOTICE:
When reusing the PCV valve sub-assembly, inspect the O-ring.
2. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
(a) Install the No. 1 engine cover sub-assembly with the bolt to the cylinder head cover sub-assembly LH.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
3. CONNECT PCV HOSE
(a) Connect the PCV hose to the cylinder head cover sub-assembly LH, and slide the clip to secure the hose.
4. CONNECT HEATER HOSE
(a) Engage the clamp and connect the heater hose.
5. INSTALL NO. 2 SURGE TANK STAY
6. INSTALL V-BANK COVER SUB-ASSEMBLY
Inspection
INSPECTION
PROCEDURE
1. INSPECT PARK/NEUTRAL POSITION SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Text in Illustration
*a
Component without harness connected
(Park/Neutral Position Switch)
...
Steering Angle Sensor (C1A47)
DESCRIPTION
The millimeter wave radar sensor assembly receives steering angle information
from the steering angle sensor (spiral cable with sensor sub-assembly). If the millimeter
wave radar sensor assembly detects a steering angle sensor (spiral cable with sensor
sub-assembly) malfunction, D ...
Registration
REGISTRATION
PROCEDURE
1. DESCRIPTION OF CODE REGISTRATION
HINT:
Registering an ID code enables the entry and start function, wireless
door lock control function and engine immobiliser function to be operated.
Code registration is needed when the certification ECU (smart key E ...