ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT REAR AIRBAG SENSOR (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check (See page ).
2. INSPECT REAR AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag has not Deployed)
CAUTION:
For rear airbag sensor removal and installation procedures, see pages and , and carefully follow the correct procedure.
(a) Perform a diagnostic system check (See page ).
(b) When the quarter panel of the vehicle or its periphery is damaged, check whether there is any damage to the rear airbag sensor. If there are any defects, such as those mentioned below, replace the rear airbag sensor with a new one:
3. INSPECT REAR AIRBAG SENSOR (for Vehicle Involved in Collision)
CAUTION:
For rear airbag sensor removal and installation procedures, see pages and , and carefully follow the correct procedure.
(a) Replace the rear airbag sensor.
Horn System
Parts Location
PARTS LOCATION
ILLUSTRATION
Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs depending on the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Exp ...
Disposal
DISPOSAL
PROCEDURE
1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY
(a) Fully extend the shock absorber piston rod, and fix it at an angle in a vise
or similar tool.
(b) Using a drill or similar tool, slowly make a hole in the shaded area shown
in the illustration, and discharge the gas inside. ...
Cruise SET Indicator Light Circuit
DESCRIPTION
The ECM illuminates the cruise control SET indicator by sending indicator output
demand signals to the combination meter assembly via CAN communication. The cruise
control SET indicator illuminates when the dynamic radar cruise control system is
controlling vehicle speed. The crui ...