INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL REAR AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) Check that the battery negative (-) terminal is disconnected.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Install the rear airbag sensor with the nut.
Torque:
9.0 N·m {92 kgf·cm, 80 in·lbf}
CAUTION:
(d) Check that there is no looseness in the installation parts of the rear airbag sensor.
(e) Connect the connector to the rear airbag sensor.
NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.
(1) Connect the connector as shown in the illustration (when locking, make sure that the outer connector locking sleeve returns to its original position and a click sound can be heard).
HINT:
When connected, the outer connector locking sleeve will slide. Be sure not to hold the outer connector locking sleeve while connecting, as it may result in an insecure fit.
2. INSTALL REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY
Click here
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
4. INSPECT SRS WARNING LIGHT
Click here
Cruise control
Use the cruise control to maintain a set speed without depressing the accelerator
pedal.
Indicator
Cruise control switch
■ Setting the vehicle speed
Press the ON-OFF button to activate the cruise control.
Cruise control indicator will come on.
Press the button again to deactivate ...
Road Test
ROAD TEST
PROBLEM SYMPTOM CONFIRMATION
HINT:
The dynamic radar cruise control system has 2 cruise control modes:
constant speed control mode and vehicle-to-vehicle distance control mode.
Vehicle-to-vehicle distance control mode is selected by default when
the dyna ...
Pump Motor Relay (C1253)
DESCRIPTION
The motor relay (semiconductor relay) is built into the master cylinder solenoid
and drives the pump motor based on a signal from the skid control ECU (master cylinder
solenoid).
DTC No.
DTC Detecting Condition
Trouble Areas
C1253
...