Toyota Tacoma (2015-2018) Service Manual: Installation
INSTALLATION
PROCEDURE
1. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY WITHOUT DOOR
|
(a) Engage the 3 hooks (B). Text in Illustration
|
|
(b) Engage the 3 hooks (A) to install the instrument panel passenger airbag assembly without door on the instrument panel.
(c) Install the 2 screws.
2. INSTALL INSTRUMENT PANEL WIRE ASSEMBLY
(a) Engage the 2 clamps to install the instrument panel wire assembly.
|
(b) Connect the 3 airbag connectors. NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness. |
|
(c) Push in the 3 airbag connector locks to install the 3 airbag connectors.
3. INSTALL NO.3 HEATER TO REGISTER DUCT
.gif)
4. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY
5. INSPECT SRS WARNING LIGHT
(See page )
Components
COMPONENTS
ILLUSTRATION
...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY WITHOUT DOOR (for Vehicle
not Involved in Collision)
(a) Perform a diagnostic system check (See pa ...
Other materials:
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the sliding roof system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...
Camper information
This information has been prepared in accordance with regulation issued by
the National Highway Traffic Safety Administration of the U.S. Department of Transportation.
It provides the purchasers and/or prospective purchasers of Toyota vehicles with
information on truck-camper loading. Your Toy ...
Lubrication System
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT ENGINE OIL LEVEL
(a) Warm up the engine, and then stop the engine and wait for 5 minutes.
(b) Check that the engine oil level is between the low level and full level marks
on the dipstick.
If low, check for leakage and add en ...
