Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT LOW PITCHED HORN ASSEMBLY
(a) Check the operation.
(1) Apply battery voltage to the terminal 1 and body ground, and check that the low pitched horn assembly sounds. Text in Illustration
OK:
If the result is not as specified, replace the low pitched horn assembly. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL LOW PITCHED HORN ASSEMBLY
(a) Install the low pitched horn assembly with the bolt.
Torque:
20 N·m {199 kgf·cm, 14 ft·lbf}
(b) Connect the connector.
2. INSTALL RADIATOR GRILLE
Click here
Removal
REMOVAL
PROCEDURE
1. REMOVE RADIATOR GRILLE
Click here
2. REMOVE LOW PITCHED HORN ASSEMBLY
(a) Disconnect the connector. |
|
(b) Remove the bolt and low pitched horn assembly.
Reassembly
REASSEMBLY
PROCEDURE
1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG
(a) Provisionally tighten the bleeder plug to the disc brake cylinder.
(b) Install the bleeder plug cap onto the bleeder plug.
2. INSTALL PISTON SEAL
(a) Apply lithium soap base glycol grease to 4 new piston s ...
Acceleration Sensor Stuck Malfunction (C1232,C1243,C1245)
DESCRIPTION
The skid control ECU (brake actuator assembly) receives signals from the yaw
rate and acceleration sensor (airbag sensor assembly) via the CAN communication
system.
The airbag sensor assembly has a built-in acceleration sensor and detects the
vehicle condition.
If there is troub ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table. Check each symptom by ...