Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Invalid Data Received from Deceleration Sensor (C1442,C1443)

DESCRIPTION

The skid control ECU (master cylinder solenoid) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system.

The airbag sensor assembly has a built-in yaw rate and acceleration sensor.

DTC Code

DTC Detection Condition

Trouble Area

C1442

An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more.

Yaw rate and acceleration sensor (airbag sensor assembly)

C1443

An invalid data signal is transmitted continuously from the yaw rate sensor for 10 seconds or more.

Yaw rate and acceleration sensor (airbag sensor assembly)

CAUTION / NOTICE / HINT

NOTICE:

When replacing the yaw rate and acceleration sensor (airbag sensor assembly), perform zero point calibration (See page ). PROCEDURE ).

PROCEDURE

1.

CHECK DTC

(a) Turn the ignition switch off.

(b) Clear the DTC (See page ). (c) Start and idle the engine for 60 seconds, and then stop the engine. ).

(c) Start and idle the engine for 60 seconds, and then stop the engine.

(d) Check if the same DTC is recorded (See page Result Result ).

Result

Result

Proceed to

DTC output

A

DTC not output

B

A

REPLACE AIRBAG SENSOR ASSEMBLY

B

CHECK USE SIMULATION METHOD TO CHECK

Steering Angle Sensor Unusual Bank Angle Detected (C1440)
DESCRIPTION If the skid control ECU (master cylinder solenoid) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (master cylinder solenoid) stores DTC C1440 ...

Accumulator Low Pressure (C1452)
DESCRIPTION DTC Code DTC Detection Condition Trouble Area C1452 After braking, the fluid pressure inside the accumulator is below the ...

Other materials:

Disposal
DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS component, review and closely follow all applicable environmental and hazardous material regulations. Pre-disposal deployment may be considered hazardous material treatment. PROCEDURE 1. PRECAUTIO ...

Removal
REMOVAL CAUTION / NOTICE / HINT Text in Illustration *a Object Exceeding Weight Limit of Transmission Jack Be sure to perform this procedure with several people as the rear differential carrier assembly is very heavy. Be sure to follow the procedure ...

Front Right Seat Heat Sensor Circuit (B14C0)
DESCRIPTION Output to the front seat cushion heater assembly RH temperature sensor stops if one of the following occurs: 1) the temperature sensor is open or shorted; or 2) the temperature sensor is damaged and its output value does not change. DTC Code DTC Detection Cond ...

В© 2011-2024 Copyright www.ttguide.net