REMOVAL
CAUTION / NOTICE / HINT
Text in Illustration
*a |
Object Exceeding Weight Limit of Transmission Jack |
HINT:
The following procedures are for BD20 (w/o Differential Lock).
PROCEDURE
1. REMOVE REAR WHEELS
2. REMOVE REAR PROPELLER SHAFT ASSEMBLY (for 2WD)
(See page )
3. REMOVE REAR PROPELLER SHAFT ASSEMBLY (for 4WD)
(See page )
4. DRAIN DIFFERENTIAL OIL
(See page )
5. REMOVE REAR AXLE SHAFT WITH BACKING PLATE LH
(See page )
6. REMOVE REAR AXLE SHAFT WITH BACKING PLATE RH
HINT:
Use the same procedure described for the LH side.
7. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY
(a) Remove the 10 nuts, 10 washers and rear differential carrier assembly. CAUTION: The rear differential carrier assembly is a heavy component. Make sure that it is supported securely. NOTICE:
|
|
8. REMOVE REAR DIFFERENTIAL CARRIER GASKET
Slip Indicator Light does not Come ON
DESCRIPTION
Refer to Slip Indicator Light Remains ON (See page
).
WIRING DIAGRAM
Refer to Slip Indicator Light Remains ON (See page
).
CAUTION / NOTICE / HINT
NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform zero point
calibration and store system informatio ...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Rear View Monitor System
DTC Code
Detection Item
See page
C1622
Open or Short Circuit in Back Camera Signal
...
Terminals Of Ecu
TERMINALS OF ECU
1. REAR TELEVISION CAMERA ASSEMBLY
(a) Disconnect the T22 television camera assembly connector.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
Terminal No. (Symbol)
Wiring Color
Terminal Description
...