Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Steering Angle Sensor Unusual Bank Angle Detected (C1440)

DESCRIPTION

If the skid control ECU (master cylinder solenoid) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (master cylinder solenoid) stores DTC C1440 while VSC operation is temporarily disabled. It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes, which automatically clears DTC C1440, after the vehicle is returned to a normal position.

HINT:

DTC C1440 and the yaw rate and acceleration sensor (airbag sensor assembly) DTC are stored when the skid control ECU (master cylinder solenoid) determines that the vehicle is being driven at a steep bank angle and either of the following conditions is met:

  • The yaw rate and acceleration sensor (airbag sensor assembly) is installed at an angle.
  • The yaw rate and acceleration sensor (airbag sensor assembly) signal output is stuck.

DTC Code

DTC Detection Condition

Trouble Area

C1440

Driving at a steep bank angle.

Yaw rate and acceleration sensor (airbag sensor assembly)

PROCEDURE

1.

CHECK DTC

(a) Clear the DTCs (See page ). (b) Perform a road test. ).

(b) Perform a road test.

(c) Check if the same DTC is output (See page ). Result ).

Result

Result

Proceed to

DTC C1440 is output

A

DTC C1440 is not output

B

Yaw rate and acceleration sensor DTC is output

C

B

END

C

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS

A

2.

CHECK DTC

(a) Clear the DTCs (See page ). ).

HINT:

  • If the skid control ECU (master cylinder solenoid) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (master cylinder solenoid) stores DTC C1440 while VSC operation is temporarily disabled.
  • It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes, which automatically clears DTC C1440, after the vehicle is returned to a normal position.
NEXT

END

Steering Angle Sensor Initialization Incomplete (C1439,C1445)
DESCRIPTION The skid control ECU (master cylinder solenoid) acquires steering angle sensor (spiral cable with sensor sub-assembly) zero point every time the ignition switch is turned to ON and th ...

Invalid Data Received from Deceleration Sensor (C1442,C1443)
DESCRIPTION The skid control ECU (master cylinder solenoid) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system. The airbag senso ...

Other materials:

Starter Relay
Inspection INSPECTION PROCEDURE 1. INSPECT STARTER RELAY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Connection Specified Condition 3 - 5 ...

System Description
SYSTEM DESCRIPTION 1. GENERAL (a) The blind spot monitor system has the blind spot monitor function and rear cross traffic alert function. (1) Blind spot monitor function The blind spot monitor function is a function that assists the driver in making the decision to change lanes. Th ...

Open in Turn Signal Circuit (B1507,B1508)
DESCRIPTION This DTC is stored when the combination meter assembly detects an open in a turn signal light circuit, a short in a turn signal light circuit, or a short in the hazard warning light circuit. DTC No. DTC Detection Condition Trouble Area ...

В© 2011-2024 Copyright www.ttguide.net