INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to perform this procedure with several people as the transfer assembly is very heavy.
PROCEDURE
1. INSTALL TRANSFER CASE LOWER PROTECTOR
(a) Install the transfer case lower protector with the 4 bolts.
Torque:
18 N·m {184 kgf·cm, 13 ft·lbf}
2. INSTALL TRANSFER ASSEMBLY
(a) Install the transfer assembly and 2 clamps with the 8 bolts.
NOTICE:
Do not damage the lip of the transfer adapter oil seal.
Torque:
24 N·m {245 kgf·cm, 18 ft·lbf}
3. CONNECT TRANSFER BREATHER HOSE SUB-ASSEMBLY
(a) Connect the 2 transfer breather hose sub-assemblies.
(b) Engage the 2 clamps to connect the 2 transfer breather hose sub-assemblies.
4. CONNECT WIRE HARNESS
(a) for 2GR-FKS:
(1) Engage the 3 clamps to connect the wire harness.
(2) Connect the connector.
(b) for 2TR-FE:
(1) Engage the 4 clamps to connect the wire harness.
(2) Connect the connector.
5. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR
6. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
7. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
8. INSTALL PROPELLER SHAFT ASSEMBLY FRONT
9. ADD TRANSFER OIL
10. INSPECT FOR TRANSFER OIL LEAK
Portable Player cannot be Operated Using In-vehicle Device or Track Information
is not Displayed on In-vehicle Device
PROCEDURE
1.
CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL
(a) Check if track information is displayed normally on another "Bluetooth" audio
compatible vehicle of the same model.
OK:
Track information is displayed no ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK FOR TRANSPONDER KEY ECU ASSEMBLY DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Immobiliser / Trouble Codes.
(e) Check the details of the DTC(s) (See page
...
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT BUMPER ASSEMBLY
(a) w/ Fog Light:
(1) Connect the 2 connectors.
(b) Engage the 3 claws and guide to install the front bumper assembly.
(c) Remove the protective tape.
(d) Install the 6 clips.
(e) Engage the clamp.
(f) Connect the connector.
(g) Insta ...