REMOVAL
PROCEDURE
1. DRAIN TRANSFER OIL
2. REMOVE FRONT PROPELLER SHAFT ASSEMBLY
3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
4. SUPPORT TRANSMISSION ASSEMBLY
5. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
6. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR
7. SUPPORT TRANSFER ASSEMBLY
(a) Tilt the transmission assembly until the transfer assembly can be removed.
NOTICE:
Do not damage the wire harness, pipe or surrounding parts.
(b) Support the transfer assembly with a transmission jack. NOTICE: Secure the transfer assembly to the transmission jack using a belt, etc. to prevent it from falling. |
|
8. DISCONNECT WIRE HARNESS
(a) for 2GR-FKS:
(1) Disconnect the connector.
(2) Disengage the 3 clamps to disconnect the wire harness. |
|
(b) for 2TR-FE:
(1) Disconnect the connector.
(2) Disengage the 4 clamps to disconnect the wire harness.
9. DISCONNECT TRANSFER BREATHER HOSE SUB-ASSEMBLY
(a) Disconnect the 2 transfer breather hose subassemblies and detach the 2 clamps. |
|
10. REMOVE TRANSFER ASSEMBLY
(a) Remove the 8 bolts and 2 clamps. Text in Illustration
|
|
11. REMOVE TRANSFER CASE LOWER PROTECTOR
(a) Remove the 4 bolts and transfer case lower protector. |
|
Skid Control Buzzer Circuit (C1A4A)
DESCRIPTION
Based on dynamic radar cruise control system operation, the forward recognition
camera provides warnings to the driver by sounding the skid control buzzer.
DTC C1A4A is stored when a malfunction is detected in the skid control buzzer
circuit.
DTC No.
Detectio ...
Removal
REMOVAL
PROCEDURE
1. REMOVE FUEL TANK ASSEMBLY
Click here
2. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Click here
3. REMOVE FUEL PUMP GAUGE RETAINER
NOTICE:
Before performing these procedures, first cover the connectors and tube joints
of the fuel suction tube with pump and gauge ass ...
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
*1
CAMSHAFT
*2
CAMSHAFT BEARING CAP
*3
CAMSHAFT HOUSING SUB-ASSEMBLY RH
*4
CAMSHAFT TIMING GEAR BOLT (for Intake Side of Bank 1)
...